System Messages; E-Codes - Accu turn 1200 Manual Del Usuario

Equilibradora
Tabla de contenido

Publicidad

66
Trouble shooting
7.1

System messages.

The wheel balancer can show messages to the op-
erator. These may be error related (E-codes) or ser-
vice related (C-codes). The codes will be described in
the following chapters.
Whenever a code appears:
-
write it down
-
look up the code in the list. If the code is not de-
scribed, call Accu Service.
-
perform the steps described.
The format of this chapter is:
Code
Description
• Step(s) to be performed.
7.1.1

E-codes.

When the E-code is displayed, a low beep is gener-
ated.
E22
Spinning timeout.
E23
Spinning speed not reached.
E24
Spinning speed too low.
The wheel has failed to be spun up to balancing speed
within the time limit set.
• Check that the brake pedal or wheel is not blocked
by accident.
• Check the power supply.
• Call Accu Service.
E25
Reverse error.
The shaft turned in the wrong direction at a given
speed.
• Apply the brake.
• Call Accu Service.
E26
No acceleration.
Shaft acceleration was not detected.
• Call Accu Service.
E27
Slip detected.
• The wheel slips on the shaft. Mount wheel properly
insuring that sufficent torque is applied to wing nut.
E28
Speed limit reached.
• Call Accu Service.
E29
START pushbutton pressed with wheel guard raised.
Operator's Manual
ACCU 1200

Publicidad

Tabla de contenido

Solución de problemas

loading

Productos relacionados para Accu turn 1200

Tabla de contenido