Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Toyota Solara 2004-2008
KIT FEATURES
• ISO DDIN radio provision
KIT COMPONENTS
• A) Radio housing • B) ISO DDIN trim plate • C) ISO DDIN brackets
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-1761 • TYTO-01
Antenna Adapter: • Not required
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver • 10mm socket wrench
METRA. The World's best kits.
Installation instructions for part 95-8212
95-8212
C
metraonline.com
™
Table of Contents
Dash Disassembly .............................................. 2-3
Kit Assembly
– ISO DDIN radio provision ...................................... 4
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
Publicidad
Tabla de contenido
Manuales relacionados para Metra 95-8212
Resumen de contenidos para Metra 95-8212
- Página 1 • A) Radio housing • B) ISO DDIN trim plate • C) ISO DDIN brackets CAUTION! Metra recommends disconnecting the negative bat - tery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local WIRING &...
-
Página 2: Dash Disassembly
95-8212 Dash Disassembly 1. Remove the cover from the hazard light switch, unclip the switch, and then unplug and remove it. (Figure A) 2. Unclip the panel above the radio including the a/c vents and clock, and then unplug and remove the panel. - Página 3 95-8212 Dash Disassembly 4. Unclip and remove the pocket and seat heater switch panel. (Figure D) 5. Remove (4) 10mm screws securing the radio/climate control assembly, and then unplug and remove the assembly. (Figure E) 6. Remove (3) Phillips screws...
-
Página 4: Kit Assembly
800-354-6782 for more information and take steps connections to the radio. Metra recommends toward a better tomorrow. using the proper mating adapter from Metra and/ or AXXESS. Re-connect the negative battery terminal and test the radio for proper operation. 6. Reassemble the dash in reverse order of... -
Página 5: Componentes Del Kit
Instrucciones de instalación para la pieza 95-8212 Indice Toyota Solara 2004-2008 95-8212 Desmontaje tablero ..........2-3 Ensamble del kit – Provisión de radio ISO DDIN ......... 4 CARACTERÍSTICAS DEL KIT • Provisión de radio ISO DDIN COMPONENTES DEL KIT • A) Carcasa del radio • B) Placa de moldura ISO DDIN • C) Soportes ISO DDIN ¡PRECAUCIÓN! -
Página 6: Desmontaje Tablero
95-8212 Desmontaje tablero 1. Retire la cubierta del interruptor de luces de emergencia, soltar el interruptor y desenchufe y quite. (Figura A) 2. Desenganche el panel de arriba del radio, incluyendo las rejillas y hora, y entonces desconecte y quite el panel. - Página 7 95-8212 Desmontaje tablero 4. Suelte y retire el canvidad y asiento del panel interruptor del calentador. (Figura D) 5. Quite los (4) tornillos de 10mm que sujetan el radio/conjunto de control climático, y luego desconecte y quite el ensamble. (Figura E) 6.
-
Página 8: Ensamble Del Kit
Instrucciones de instalación para la pieza 95-8212 Ensamble del kit IMPORTANTE Provisión de radio ISO DDIN Si tiene dificultades con la instalación 1. Coloque a presión los soportes ISO DDIN en el borde de este producto, llame a nuestra línea interior del carcasa del radio ISO DDIN .