Using The Tuner - Alesis AcoustiFX Manual De Inicio Rápido Del Usuario

Effect Quick Reference
Refer to chapter 10 of the User Manual
for more details on effect modules.
1. COMP/LIMIT – increasing levels of
compression (C1-C9) and limiting (L1-
L9).
2. TYPE – various types of acoustic-
guitar sounds such as Clean, Warm,
Bright, Rhythm, Jumbo and Drive.
3. EQ – includes a high-pass filter at
80Hz and four bands of EQ (LOW,
LO MID, HI MID and HIGH) that
range from -12dB to +12dB in 1.2dB
steps. See page 27 of the User Manual
for details.
4. EDGE – a filtered limiter that gives
your guitar a bright, edgy sound; it does
this by adding a high-pass filter to the
signal, feeding that filtered signal into a
limiter, and then mixing it back with
the original signal.
5. NOISE GATE – increasing levels of
noise gating, which eliminates
unwanted noise by muting the audio
signal until it rises above a certain point.
6. FX1 – a variety of stereo effects such
as Chorus, Phaser, Flanger, Tremolo,
12-String, Slow Attack, Step Filter,
Wah, Rotary, Cry and more; most have
a separate setting for pedal control.
7. PARAM – direct-control parameter for
FX1; for most effects, can be set to
pedal control independent of the FX1
setting.
Visual Guide to Tuning
The bottom four segments rotate counterclockwise if
pitch is low. The top four rotate clockwise if the
pitch is high. An 8 means you're in tune.
= no pitch detected.
Here are the 12 possible
pitches (a decimal point
indicates a sharp):
8. FX2 – various delay-based effects such
as reverbs (Hall, Room, Plate and
Reverse), delays (Doubling, Stereo
Delay, Ping Pong Delay and Tape
Delay) and Echo; these also have
settings for pedal control.
9. PARAM – direct-control parameter for
FX2; for most effects, can be set to
pedal control independent of the FX2
setting.
10. LEVEL – the level of the current
program.
Selecting, Editing and Storing
Programs
1. In PLAY mode, use the foot pedals or
VALUE knob to select a program.
2. Turn the EFFECT knob to the module
or parameter you wish to edit.
3. Turn the VALUE knob to change the
value of the module or parameter.
4. To store your changes, press the
VALUE knob and then turn the knob
to select a store location. Press the
VALUE knob again to store the
program.

Using the Tuner

1. In PLAY mode, activate the tuner by
pressing both pedals at the same time
to enter BYPASS mode, or hold down
the pedals for more than half a second
to enter MUTE mode.
2. Play the open string you wish to tune.
Use the following guide when tuning:
Low
In tune
High