Before First Use - LD Systems ROADMAN 102 Guía Rápida

Before first use

Connect the power cord and charge the battery fully (battery already
connected)
Important: Set LINK SET on the back to the MASTER position
first use
Turn on the unit at the main switch (Power)
switch lights up.
Playing CDs
To turn on the CD player, press the Power/Volume knob for
second, gently insert a CD, increase the volume by turning the Power/
Volume knob to the right, and set the Roadman to the desired overall
volume using the master volume control (red knob
using the hanDhelD miCroPhone for the first time
Turn on the receiver at the Power/Volume knob
right (past the detent position). Insert the batteries in the handheld
microphone and turn it on. To synchronise the radio frequency,
position the uncovered infrared interface (IR above the battery
compartment ) so that there is a direct line of sight between it and
8
the infrared interface of the receiver
receiver. If the transmission was successful, the red RF-LED on the
receiver will light up. Increase the volume by turning the Power/
Volume knob 5 to the right, and set the Roadman to the desired
overall volume using the master volume control (red knob
using the Belt PaCk transmitter for the first time
Turn on the receiver at the Power/Volume knob
right (past the detent position). Insert the batteries in the belt pack
transmitter and turn it on. To synchronise the radio frequency, position
the uncovered infrared interface (on the back
direct line of sight between it and the infrared interface of the receiver
. Press the ASC button on the belt pack transmitter (the green LED
6
will blink), then press the ASC button
transmission was successful, the red RF-LED on the receiver will light
up. Increase the volume by turning the Power/Volume knob
right, and set the Roadman to the desired overall volume using the
master volume control (red knob
Battery maintenanCe instruCtions (reChargeaBle leaD
Battery)
Recharge the battery fully at every opportunity. Never completely
discharge a rechargeable lead battery or store it in discharged or
semi-charged condition. During extended periods of disuse and
storage, the battery must be recharged fully at regular intervals.
2
2
. The red light in the
3
).
4
5 by turning it to the
7
. Press the ASC on the
6
4
5 by turning it to the
9 ) so that there is a
7
on the receiver. If the
5
).
4
1
.
1
).
to the
9
8