General Description; Extent Of Delivery; Overview; Function Description - Grizzly EHS 900 L Traducción Del Manual De Instrucciones Original

GB

General Description

Extent of delivery

- Long-handled hedge trimmer
(two-part)
- Blade protection
- Leg protection
- Shoulder strap
- Instruction Manual
See the front fold-out page for illus-
trations.

Overview

1 Safety blade
A
2 Gearbox
4 Stop lever fixing
5a Stop lever
5b Safety lever
6 Handle for adjusting the blade
beam
7 Front arm
8 Safety button
9 Pivotal centre
10 Round handle
11 Safety slide
12 Deadman switch
13 On/off switch
15 Mains cable
16 Shoulder strap
17 Eye (for shoulder strap)
18 Leg protection
19 Blade protection
C 20 Square nuts
21 Screws
22 Assembly block
90

Function Description

The electric hedge trimmer is driven by an
electronic motor. The equipment is double-
insulated for safety and does not require
earthing.
The hedge trimmer is equipped with a dou-
ble-sided safety cutter bar. When cutting,
the blades move backwards and forwards
in linear motion. The impact protection on
the tip of the cutter bar prevents unpleas-
ant recoils should the trimmer come into
contact with walls, fences and so on.
The unit can only be operated with the
deadman switch depressed, in order to
protect the operator. In addition, the hand
guard protects against branches and
briars.
Please note the following descriptions for
the function of the operating components.

Technical Data

Electrical Hedge Trimmer .......EHS 900 L
Input voltage rating.......230-240 V~, 50 Hz
Input power ......................................900 W
Safety class .........................................
Degree of protection
Weight (without cable) ................... 6,22 kg
Cutting length ................................ 410 mm
Cutting capacity ............................... 20 mm
Acoustic pressure level (L
........................... 89,2 dB(A); K
Measured sound power level (L
.........................95,63 dB(A); K
Guaranteed sound power level ..97,0 dB(A)
Vibration at the handle
............................. 7,096 m/s
Vibration at the round handle
............................. 5,862 m/s
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration of
conformity.
Technical and optical changes may be
undertaken in the course of further de-
..........................IP 20
)
pA
= 1,11 dB
pA
)
WA
= 1,11 dB
WA
; K = 1,5 m/s
2
; K = 1,5 m/s
2
II
2
2