Installing Freestanding Version; Installing Built-In Version; Mounting The Door Handle (Optional) - Dometic DS200 Instrucciones De Montaje Y De Uso

Installing and connecting the mini fridge
• Observe the following installation dimensions:
fig. i
– DS200:
fig. j
– DS300:
fig. k
– DS400:
fig. l
– DS600:
• Keep objects clear of openings in the housing or installation structure (such as
ventilation slots, etc.).
6.2

Installing freestanding version

Observe the following to set up the mini fridge in a freestanding position:
• Ensure that the cover for protecting the hot components of the cooling unit is
present.
• Ensure that the floor frame is in place to provide adequate air circulation.
➤ Place the mini fridge on a level surface. Use a water level to check this.
6.3

Installing built-in version

!
CAUTION! Health hazard
To avoid a hazard due to instability of the device, it must be fixed in
accordance with the instructions.
Observe the following instructions if you wish to install the mini fridge in cabinetry:
• Place the mini fridge on a level surface. Use a water level to check this.
• Maintain 20 mm clearance to the walls.
• Air must be able to circulate without any hindrance (fig. 5, page 7).
• The entire cooling unit must extend into the ventilation duct.
• The air in the ventilation duct may not be heated by other heat sources.
• The ventilation grille must have a cross-section of at least 200 cm².
Proceed as follows to install the mini fridge (fig. 6, page 8):
➤ Erect the mini fridge and screw on the feet of the device.
6.4

Mounting the door handle (optional)

➤ Proceed as shown to mount the door handle (fig. 7, page 8).
➤ Proceed as shown to disassemble the door handle (fig. 8, page 8).
24
, page 12
, page 13
, page 14
, page 15
DS200 – DS600
EN