Auxiliary Mode - RIDGID R84086 Manual Del Operador

OPERATION
 Press either arrow button to scroll through the preset
positions.
 Press the PRESETS button to store the frequency in the
selected memory location.
To recall a preset frequency:
 Press the PRESETS button and quickly release to cycle
through stored frequencies.
TONE SELECTION
See Figure 4, page 11.
 Press the SOUND button to enter BASS adjust mode.
 Adjust the bass setting using the volume knob or arrow
buttons.
 Press the SOUND button to save the new bass setting
and enter TREBLE adjust mode.
 Adjust the treble setting using the volume knob or arrow
buttons.
 Press the SOUND button to save the new treble setting
and return to original operating mode.
STREAMING AUDIO USING A BLUETOOTH
ENABLED DEVICE (NOT INCLUDED)
See Figures 4 - 5, pages 11 - 12.
 Press the button to enter BLUETOOTH
can also enter BLUETOOTH
MODE button to cycle through available modes until
is highlighted.
NOTE: The radio will automatically attempt to connect
to the last device it was paired to. If no device has been
previously paired, will automatically begin blinking.
 Set your device to search/scan for available BLUETOOTH
signals, then select "STRM–RIDGID Mini Radio" from the
list. No password or PIN is required for connection.
 When the device has successfully paired with the radio,
you will hear an audible tone and
NOTE: If the radio does not pair with your device, turn
the power to the radio off, wait 5 seconds, then turn the
power back on and start the pairing process again.
 When streaming audio from a BLUETOOTH
device, press the arrow buttons on the radio to go to the
previous or next track. Press the PRESETS button to
cycle between pausing and playing the audio.
NOTE: These controls may not be supported by the
BLUETOOTH device and/or streaming application you
®
are using.
 To reach maximum volume when controlling the sound
using the radio's volume knob, make sure the volume on
your device is also at the maximum setting.
 To disconnect the current device to allow connection to
another BLUETOOTH
the button for 3 seconds. When
radio is ready to pair.
mode. You
®
mode by pressing the
®
will stop blinking.
®
enabled device, press and hold
®
begins to blink, the

AUXILIARY MODE

See Figures 6 - 7, page 12.
The radio can be used as an amplifier for your MP3 player,
CD player, smartphone, tablet, and other music devices.
To use the auxiliary mode:
 Press the MODE button to select AUX mode.
 Connect the included auxiliary cable to your external
device.
 Connect the other end of the auxiliary cable to the AUX
jack located on the side of the radio.
 The external device must be ON and in PLAY mode for
sound to be heard through the speakers.
 All external device controls can be used normally while
connected to the radio.
NOTE: Volume for any device connected through the
auxiliary connector can be adjusted using the volume
control for that device and/or with the volume knob on
the radio.
 Turning the radio OFF will NOT turn the external device
OFF.
®
 The auxiliary cable DOES NOT provide charging function.
 For complete operating instructions for all external de-
vices, always refer to the manual that was included with
your model.
USB DEDICATED CHARGING PORT
See Figures 6 and 8, page 12.
The USB dedicated charging port provides charging power
of up to 1 Amp for your cell phone, MP3 player, tablet, or
other USB devices.
®
NOTICE:
Attempting to charge devices rated more than
1 Amp could damage the USB dedicated charging
port and/or the device.
 Connect one end of a USB cable (not provided) to your
USB device.
enabled
 Connect the other end of the USB cable to the USB
dedicated charging port to begin charging the device.
NOTE: The USB dedicated charging port provides power
only; it does not provide any communication capabilities.
 If the radio contains a charged battery pack, the USB
dedicated charging port will continue to function for ap-
proximately 1 hour after turning the radio OFF. If the radio
remains inactive after this time, charging will stop. Turn
the radio on to resume operation.
7 - English