Maintenance And Cleaning; Modifications And Spare Parts - DAB PULSAR Instrucciones Para La Instalación Y El Mantenimiento

FIG. 3
10. STARTING
10.1 Priming of the PULSAR DRY
Before starting, prime the pump, filling it with the liquid that is to be pumped through the hole to be made in the delivery pipe. (Fig.2, pag. 2).
Priming must be repeated whenever the pump has remained out of use for long periods of time or when air has got into the system.
•
Turn the differential magnetothermal switch upstream from the pump to position I (ON) and wait until the water comes out of the delivery
pipe.
•
If malfunctions are found, disconnect the pump from the power supply, turning the differential magnetothermal switch to position 0 (OFF)
and consult the chapter on "TROUBLESHOOTING".
•
The pump may be started and stopped:
- Manually by means of the differential magnetothermal switch upstream from the system.
- Automatically for versions with a float when water level rises.
10.2 Regulating the float switch PULSAR
By lengthening or shortening the stretch of cable between the float and the fixed point (cable block on the handle - Fig. 4, pag. 1) it is possible to
regulate the level at which the pump switches off (STOP). Ensure that the float can move freely.
Ensure that the stop level does not uncover the filter.
11. PRECAUTIONS
•
The suction filter in PULSAR electropumps must always be present during pump operation.
•
The pump must not be started more than 30 time in one hour so as not to subject the motor to excessive thermal stress.
•
DANGER OF FROST: When the pump remains inactive for a long time at temperatures of less than 0°C, it is necessary to ensure
that there is no water residue which might freeze, causing cracking of the pump components.
For PULSAR DRY electropumps, drain the pump through the drainage cap located behind the intake coupling (Fig.2, pag. 2).
This operation is also recommended in the case of prolonged inactivity of the pump at normal temperature.
•
If the pump has been used with substances that tend to deposit, rinse it after use with a powerful jet of water so as to avoid the
formation of deposits or scale which would, tend to reduce the pump characteristics.

12. MAINTENANCE AND CLEANING

In normal operation the pump does not require any type of maintenance, thanks to the mechanical seal lubricated in an oil bath and
to the greased-for-life bearings. The electropump can only be dismantled by competent skilled personnel, in possession of
the qualifications required by the legislation in force. In any case, all repair and maintenance jobs must be carried out only after
having disconnected the pump from the power mains. During dismantling it is necessary to pay great attention to sharp parts which may cause
injury.

13. MODIFICATIONS AND SPARE PARTS

Any modification not authorized beforehand relieves the manufacturer of all responsibility. All the spare parts used in repairs
must be original ones and the accessories must be approved by the manufacturer so as to be able to guarantee maximum safety of
the machines and systems in which they may be fitted.
ENGLISH
16