Specifications - Southwire MAXIS XD1 Manual De Instrucciones De Operación Y Mantenimiento

TROUBLESHOOTING
1. If Capstan (1) fails to turn, ensure ample battery supply to the
hand drill is available.
2. Check drill hand chuck for tightness before every use to ensure
there is no slippage on the Input Shaft Chuck Adaptor (3).
3. If drill is in motion and Capstan (1) does not pull rope, ensure
indexing pin on gear box output shaft is aligned with groove in
Capstan (1). Rotate and push Capstan (1) towards Gear Box (4) to
lock into place.
MAINTENANCE
1. Gear box (4) is filled with high temperature lubricating grease,
no maintenance of the gear box is required.
2. Input Shaft Chuck Adaptor (3) is equipped with a three sided
harden steel extension. If for any reason this shaft is worn down
or stripped, call your local distributer or Southwire Tools and
Equipment for a replacement.
3. Routinely inspect all aspects of XD1 puller to ensure puller is
in proper working order prior to usage. If parts are missing or
broken, Do Not Use, have puller serviced at an authorized
Southwire Repair Center.
13

SPECIFICATIONS

• Model# XD1
• Stock # 65-09-09-01
• Length (Fully Extended)- 34.5"
• Length (Collapsed)- 28.5"
• Width-8"
• Height- 8.75"
• Weight – 8lbs.
• Pulling Speed Low- 27 fpm (No Load) Relative to
Drill Output
• Pulling Speed High- 106 fpm (No Load) Relative to
Drill Output
• Recommended Pulling Rope- 1/4" QWIKrope™
14