Special Safety Rules - Ryobi ERT1400RV Manual De Utilización

GB
FR DE ES
DESCRIPTION
1. Speed selection sight window
2. Variable speed control selector
3. Handle
4. Lock-off button
5. Spindle lock button
6. Parallel guide lock knob
7. Chip shield
8. Depth stop
9. Stop bar
10. Stop bar lock knob
11. Zero reset indicator
12. Scale
13. Power cord
14. Plunge lock lever quick release button
15. Switch
16. Router base
17. Sub-base
18. Spanner
19. Parallel guide
20. Collet nut
21. Threaded post
22. Collet
23. Workpiece
24. Dust port
25. Depth of cut
26. Width of cut
27. First pass
28. Second pass
29. Fine height adjuster knob
30. Fine height adjuster quick release button
31. Live tool indicator
32. Template guide
33. Screw
34. Nut

SPECIAL SAFETY RULES

Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its cord. Contact with
a "live" wire will make exposed metal parts of the tool
"live" and shock the operator.
Know your power tool. Read the operator's manual
carefully. Learn its applications and limitations, as well
as the specific potential hazards related to this tool.
Following this rule will reduce the risk of electric shock,
fire, or serious injury.
Always wear safety glasses. Everyday eyeglasses
have only impact-resistant lenses; they are NOT
safety glasses. Following this rule will reduce the risk
of serious personal injury.
Protect your lungs. Wear a face or dust mask if the
operation is dusty. Following this rule will reduce the
risk of serious personal injury.
IT NL PT DK SE FI NO RU PL CZ
English
Protect your hearing. Wear hearing protection during
extended periods of operation. Following this rule will
reduce the risk of serious personal injury.
Inspect tool cords periodically and, if damaged,
have repaired at your nearest Factory Service
Center or other Authorized Service Organization.
Constantly stay aware of cord location. Following
this rule will reduce the risk of electric shock or fire.
Check damaged parts. Before further use of the
tool, a guard or other part that is damaged should
be carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other conditions
that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced by an
authorized service center. Following this rule will reduce
the risk of shock, fire, or serious injury.
Do not abuse cord. Never carry the tool by the cord or
yank it to disconnect it from the receptacle. Keep cord
away from heat, oil, and sharp edges. Following this
rule will reduce the risk of electric shock or fire.
Inspect for and remove all nails from lumber
before routing. Following this rule will reduce the risk
of serious personal injury.
Do not operate tool while under the influence
of drugs, alcohol, or any medication. Following
this rule will reduce the risk of electric shock, fire, or
serious personal injury.
Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If you
loan someone this tool, loan them these instructions
also.
Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains
chemicals known to cause cancer, birth defects or other
reproductive harm.
Some examples of these chemicals are:
lead from lead-based paints
crystalline silica from bricks and cement and
other masonry products
arsenic and chromium from chemically-treated
lumber
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals, work in a well ventilated
area, and work with approved safety equipment, such
as those dust masks that are specially designed to ¿ lter
out microscopic particles.
1
HU RO LV LT EE
WARNING
HR SI SK GR TR