Publicidad
US
Key to symbols
Attention! Important warning against
!
personal injury or material damage.
Note, tip or reference
Water draining
Note assembly details
Mounting-/functional test
Mismounting
Hot water
ES
Explicación de símbolos
Atención! Indicación importante como
¡
!
advertencia de daños personales o materiales.
Indicación, recomendación o referencia
El agua fluye
Respetar las particularidades de montaje
Prueba de montaje-/funcionamiento
Malo función
Agua caliente
CA
Explication des symboles
Attention! Avertissement important concernant
!
les risques de blessures ou de dommages
matériels.
Remarque, conseil ou renvoi
L'eau coule
Respecter le détail de montage
Contrôle du montage/de fonctionement
Faux montage
Eau chaude
Drain closed
STOP
Cold water
El agua no fluye
STOP
Agua fria
L'eau ne coule pas
STOP
Eau froide
US
Important information, please read.
General instructions
IMPORTANT SAFETY INSTRUCTIONS
WARNING - This product must be installed by a
qualified installer, in accordance with local codes and
regulations and according to the enclosed installation
instructions.
- Safety, functionality and loudness of the product can
only be guaranteed if the information in this instruction
is oberserved. Ignoring this may cause damage. The
manufacturer accepts no liability for damages resul-
ting from non-oberservance of the instructions.
- The attached instructions shall be handed to the user
after assembly and functional test.
- Technical changes reserved.
Range of operation:
Application is possible in connection with pressurized
storage heaters and hydraulically or thermally control-
led instantaneous heaters.
Not possible is the operation with low-pressure
storage heaters (displacement water heaters).
For use with shower heads, hand showers and body
sprayers rated at 1.5 gpm (5.7 l/min) or higher.
Technical data
Flow pressure:
Greater 72.5 psi fit pressure reducing valve.
Test pressure:
Operating pressure:
Temperature, hot water inlet:
Recommended (energy saving)
* For temperature setting: Please follow all applicable
local plumbing codes.
Water connection:
Tightening torque, cartridge:
Limitation of outlet temperature will be described in the
mounting and operating instructions of the regarding
shower bathtub board.
For installation refer to the dimensional drawing on
page 13.
Flush piping system prior and after installation of
faucet thoroughly.
Check connections for leakage.
To Obtain warranty repair or replacement
Service, please contact KEUCO LP Customer
Service at: office-usa@keuco.com.
2 - 16
min 8 psi
recommended 14.5 - 72.5 psi
max 145 psi
232 psi
max 176° F*
:
120 - 140° F*
hot - marked red
cold - marked blue
221 - 265 lbf in
Publicidad
