Fuse Replacement - Schumacher Electric OBD-L Manual Del Usuario

EN
OFF position and wait 25 minutes. This ensures that all retained accessories are in a power OFF state (for example: fan,
headlights, etc.).
3. Connect the 12V power plug of the OBD-L to your 12V DC power supply. Make sure plug is firmly in place. The yellow
CONNECTED LED in box #1 will light, indicating a good connection.
WARNING: Do not connect the 12V power plug of the OBD-L into the power outlet within the
same vehicle from which you are removing the battery.
4. Connect the OBD-L 12V OBD diagnostic connector to the vehicle's OBD plug. Make sure the
connector is fully engaged. The yellow CONNECTED LED in box #2 will light, indicating a
good connection.
5. Verify that the green PROCEED LED in box #3 is lit, indicating you may disconnect the
vehicle's battery. If the red DO NOT PROCEED LED in box #3 lights, do not disconnect the
vehicle's battery; disconnect the OBD-L and check the internal fuse or contact qualified
service personnel for electrical system repair.
6. Disconnect the vehicle's battery cables and cover the positive and negative cables with an
insulator, such as electrical tape. This prevents the connectors from touching metal, each
other, or the chassis and causing a short circuit, due to the vehicle's electrical system
receiving power through the OBD connection.
WARNING: When working with the vehicle's battery, review all of the battery manufacturer's safety instructions, warnings
and directives regarding battery disconnection, removal and replacement.
7. Remove the old battery and put the new battery into position.
8. Remove the insulator from the positive cable and connect it to the positive terminal of the new battery.
9. Remove the insulator from the negative cable and connect it to the negative terminal of the new battery.
10. Once the new battery is connected, unplug the memory saver's OBD connector from the vehicle's OBD plug and
disconnect the 12V DC plug from the 12V power supply.

FUSE REPLACEMENT

The 12V power plug adaptor operates with a supplied 5A 250V glass fuse.
1. Access the fuse compartment by turning the tip of the adaptor in a counterclockwise direction.
NOTE: The fuse is spring-loaded and caution must be taken to ensure that the spring does not "fly out" of the end of the
fuse compartment when it is opened.
2. Remove the fuse and replace it with one of the same type and rating.
3. Close the adaptor by turning the tip in a clockwise direction.
4 / 17