Assembly - Outdoor Leisure PMSQSS40 Manual Del Proprietário

Tools Required:
• 1) #2 Phillips Head Screwdriver
• 2) Adjustable Wrenches
Hardware packet provided with heater may contain more parts than needed for heater assembly.
1. Tighten 3 nuts on emitter top.
Figure 1 - Emitter Top
2. Remove protective film from 3 reflector
pieces. Using 3 x M5 screws from the top
side, connect 3 reflector parts together.
Screw
Figure 2 - Reflector Assembly
123748-01A

aSSEMBLy

3. Attach reflector assembly and reflector
cap to emitter assembly using 3 screws,
nuts and washers.
Figure 3 - Reflector and Cap Assembly
Figure 4 - Reflector and Emitter Assembly
www.desatech.com
Screw, Nut and Washer
5