Using The Transmitter And The App - Dometic WAECO VT100WiFi Instrucciones De Montaje Y De Uso

Using the transmitter and the app

Connecting the transmitter to the reversing light (no continuous voltage)
I
NOTE
 For this type of connection, only the cameras without the motorised
protective cover can be used.
 On some vehicles, the reversing light only works when the ignition is
switched on. In this case, you must switch on the ignition to identify the
positive and earth cables.
➤ Connect the red cable of the transmitter (5) to the positive cable of the reversing light.
➤ Connect the black cable of the transmitter (6) to the earth terminal (–) on the reversing
light or to the earth terminal on the bodywork.
➤ Connect the green cable of the transmitter (4) to the positive cable of the reversing
light.
➤ Connect the camera connector (3) to the camera.
8 Using the transmitter and the app
8.1 Installing the WAECO VT100WiFi app
To be able to use the system, you need to install the manufacturer's free app on your
receiving device before initial use.
You can find the app in Google Play Store
©
(iOS ) under the name WAECO VT100WiFi.
8.2 Starting the transmitter and app
I
NOTE
 Activate the wireless reception of your receiving device.
 Change the name and password of the wireless network after you have
connected your receiving device for the first time.
When connected to a continuous operating voltage
➤ Switch the vehicle ignition on.
✓ 6 – 8 seconds after starting the vehicle, the transmitter is ready for operation.
➤ Connect your receiving device to the wireless network of the transmitter. Use the
address and the password to do this, which can be found on the transmitter housing.
➤ Start the WAECO VT100WiFi app on your receiving device.
✓ The receiving device displays the camera image.
✓ After three seconds without further action, the receiving device switches to full-screen
mode.
✓ Double-click on the screen to open the control bar.
26
© ©
(Android ) and in the Apple
VT100WiFi
© ©
App Store
EN