Conducting A Test; Observing Result After A Test; Caution - BK Precision 600 Manual De Instrucciones

2.2.3 Conducting a Test

Test can be conducted any time by pressing the "Load
Test" key.
By doing so the 'Test On' LED starts glowing.
Typically, it glows for about 2 seconds. Thereafter the
'Ready' test starts blinking.
(The blinking time depends on the AH range slsected).
Thereafter it becomes steady.
Note: User cannot conduct a test while the 'Ready' LED is
blinking.

2.2.4 Observing Result After a Test

By default the Batt. Voltage is displayed on the display. To
observe the Balance Capacity left, press the 'Display Mode'
switch.
The display will show the capacity in percentage.
Note: Balancce Capacity can have a meaningful value only after
conduction of a test. At power on, a value of 0 is shown. Hence
Balance Capacity should be seen only after conduction of a
test. To observe No Load Batt. Voltage, press the 'Display
Mode Key'. The display will show the No Load Batt. Voltage.

2.3 CAUTION

1) Do not connect Model 600 to a voltage source more than 20V.
2) Do not connect the unit to a battery connected in circuit.
6