Setting Surface Controls; Operating The Gas Surface Controls; Setting Proper Surface Burner Flame Size - Kenmore 790.3690 Serie Manual De Uso

setting surface Controls

Do not place plastic
items such as salt and pepper shakers,
spoon holders or plastic wrappings
on top of the range when it is in
use. These items could melt or ignite.
Potholders, towels or wood spoons could
catch fire if placed too close to a flame.
In the event of an electrical power outage,
the surface burners can be lit manually.
To light a surface burner, hold a lit match
to the burner head, then slowly turn the
surface control knob to liTe. After burner
lights push in and turn knob to desired
setting. Use caution when lighting surface
burners manually.
Figure 1
Figure 2
Figure 3

Operating the gas surface Controls:

1. Place cooking utensil on surface burner.
2. Push the surface control knob down and turn counterclockwise out of
3. Release the knob and rotate to the LITE position (See Figure 2).
4. Visually check that the burner has a flame.
5. Turn the control knob counterclockwise to the desired flame size. The

Setting Proper Surface Burner Flame Size

For most cooking, start on the highest control setting and then turn to a
lower one to complete the process. Use the recommendations below as a
guide for determining proper flame size for various types of cooking. The
size and type of utensil used and the amount of food being cooked will
influence the setting needed for cooking.
*Flame Size
High Flame
Medium Flame
Low Flame
*These settings are based on using medium-weight metal or aluminum
pans with lids. settings may vary when using other types of pans.
The color of the flame is the key to proper burner adjustment. A good flame
is clear, blue and hardly visible in a well-lighted room. Each cone of flame
should be steady and sharp. Clean burner if flame is yellow-orange.
Regardless of size, always select cookware that is suitable for the amount
and type of food being prepared. Select a burner and flame size appropriate
to the pan. Never allow flames to extend beyond the outer edge of the pan.
Never extend the flame beyond the outer edge of the utensil. A higher
flame wastes heat and energy and increases your risk of being burned
by the flame (Figure 3).
For deep fat frying, use a thermometer and adjust the surface control knob
accordingly. If the fat is too cool, the food will absorb the fat and be greasy.
If the fat is too hot, the food will brown so quickly that the center will be
undercooked. Do not attempt to deep fat fry too much food at once as the
food will neither brown nor cook properly.
RighT
Proper
flame size
WROng
improper
flame size
the OFF position (See Figure 1).
Note: All four electronic surface ignitors will spark at the same time.
However, only the burner you are turning on will ignite.
control knobs do not have to be set at a particular setting. Use the knob
indicator settings to adjust the flame as needed. DO nOT cook with
the surface control knob in the LITE position (The electronic ignitor will
continue to spark if the knob is left in the LITE position).
Type of Cooking
Start most foods; bring water to a boil; pan broiling.
Maintain a slow boil; thicken sauces, gravies; steaming.
Keep foods cooking; poach; stewing.
9