How To Change Frequencies; Troubleshooting - Carson CE-10 Desert Quad Manual De Usuario

h. How to Change Frequencies
Transmitter
A rapid change of frequencies is possible simply by unplugging
an interchangeable plug in crystal on the back of the
transmitter and then
plugging in another one
Transmitter crystal
of a different frequency.
Crystals for both the
transmitter and receiver
must be matched with
each other.
Make sure that the
crystal is fully inserted
in the transmitter and
receiver, not partially.
i. Troubleshooting
Problem
Model doesn´t move
Loss of control
Doesn´t run straight
Doesn´t stop
Doesn´t reverse
Running too slowly
CARSON CE-10 Desert Quad 50 040 4012 • E-Bone 50 040 4006
Cause
Transmitter or chassis power switch is not "ON"
Polarity or battery type is wrong
Batteries have run down
Batteries have run down
Antenna is missing or not attached properly
R/C model using same band (frequency) is
nearby
Steering trim is not adjusted correctly
Front and rear wheel nuts are too lose
Throttle trim is not adjusted correctly
Throttle trim is not adjusted correctly
Wrong action
Batteries have run down
Motor has lost power
Rear wheel nuts are too loose
Dust or foreign objects are inside gears
Receiver
Plug in an interchangeable crystal into the receiver for a rapid
change of frequencies.
Receiver crystal
Correction
Switch power on
Check polarity and type
Change batteries or charge them
Change batteries or charge them
Attach antenna and extend transmitter
antenna to full length
Run model in different area or change crystal
Make adjustment
Tighten wheel nuts
Make adjustment
Make adjustment
Control properly
Change batteries or charge them
Change to spare motor
Tighten wheel nuts
Turn the power switch "OFF" and clean out
gears
GB
11