Seguridad General - Genie Z-62/40 Manual Del Operario

Manual del operario

Seguridad general

Seguridad general
DANGER
Tire Pressure:
Lug NutTorque:
Tip-over Hazard
Dry bolts:
Failure to replace tires with tires
of same specification will result
in death or serious injury.
Lubricated bolts:
Tires are critical to machine
stability.
Do not replace factory-installed
tires with high flotation tires.
Only replace factory-installed tires
with tires of same specification and
ply rating.Tire Size: 355/55 D625,
14 ply
WARNING
Compartment access
Only trained maintenance personnel
is restricted.
should access compartments. Access
Contact with
by operator is only advised when
components under
performing Pre-operation Inspection.All
any cover may result
compartments must remain closed and
in serious injury.
secured during operation.
28175 H
DANGER
Tip-over Hazard
Altering or disabling angle sensor
can result in machine tip-over.
Machine tip-over will result in
death or serious injury.
Do not move, alter or disable
angle sensor.
82314 B
6
DANGER
70 psi / 4.92 bar
240 ft-lbs /
325 Nm
Maintain required clearance.
180 ft-lbs / Line Voltag e
244 Nm 0 o t 5 0 K V
Electrocution Hazard
50 to 200KV
Death or injury can result from contacting electric
200 to 350KV
power lines.
350 to 500KV
Always contact the electric power line owner. The
500 to 750KV
electric power shall be disconnected or the power
lines moved or insulated before machine operations
750 to 1000KV
begin.
114390 A
82677 D
DANGER
Burn Hazard No smoking. No
Fuel and fumes flame. Stop
can explode engine.
and burn.
114258 A
Primera edición • Primera impresión
DANGER
Explosion / Burn Hazard
Ignition of explosive gases or contact with corrosive
acid will cause death, burns or blindness
Required Clearance
Keep all open flames and sparks away. Wear
1 0 t f 3 0 . m
personal protective equipment, including face
15 ft 4.6 m shield, gloves and long sleeve shirt.
20 ft 6.1 m
READ MANUALS
Read all manuals prior to operation.
25 ft 7.6 m
35 ft 10.6 m
DO NOT OPERATE equipment if you do not
understand the information in the manuals.
45 ft 13.7 m
Consult your supervisor, the owner or the
manufacturer.
DANGER
WARNING
Tip-over Hazard Annual Inspection Record
Failure to complete required inspections
Altering or disabling limit
could result in death or serious injury.
switches can result in machine
tip-over. Machine tip-over will
Scheduled maintenance
result in death or serious injury. inspections must be
completed as specified in
the appropriate service
manual.
Use this decal to record
Do not alter or disable limit
the date of the annual
inspection, the initials of
switch(s).
the inspector and the
machine owner.
31060 C
Model Serial number
Date of
Inspection
Inspected
by
Machine
Owner
Z-62/40
WARNING
Electrocution/Burn Hazard
Failure to disconnect all
the batteries before
performing service on this
machine may result in
death or serious injury.
Disconnect all the batteries
before performing service on
this machine.
97865 B
31788 C
Use the maintenance
inspection report in the
service manual for required
recordkeeping. Keep
records on all inspections
for four years.
Maintenance inspections
must be completed by a
person trained and qualified
on the maintenance of this
machine.
52865 B
N.º de pieza 1257652SP