Padlocks: Conventional Key-In-Knob - Key Retaining - Schlage Kryptonite KS Serie Manual De Instrucciones

KEY-IN-KNOB CYLINDER
KEY RETAINING
1
2
3
6
7
8
9
10
12
PARTS
ITEM
1. Shackle
2. Shackle Spring
3. Locking Ball Bearings
4. Cylinder Housing Screw
5. Shackle Mounting Screw
6. Lock Body
7. Key Retaining Locking Cam
8. Key Stop
9. Driver
4
10. Cylinder
5
11. Cylinder Housing
12. Bumper
LOCKING CAM IDENTIFICATION
SERIES
10 KNK
20 KNK
40 KNK
80 KNK
90 KNK
70 KNK
C1 C2
11
Locking Cams
* The only required part to make your lock key
retaining is the key retaining locking cam.
CYLINDER HOUSING IDENTIFICATION
SERIES
20 KNK
40 KNK
70 KNK
80 KNK
90 KNK
10 KNK
1
ASSEMBLY INSTRUCTIONS
1. Grease shackle spring and insert into the
ITEM #
shackle hole nearest the tapped hole.
(Figure 1)
KZ35AA1 Figure 1
KZ35AA2
KZ35AA3
KZ35AA4
KZ35AC1
KZ35AC2
KZ32BB0
KZ35AB1
KZ35AB2
2. Insert long end of shackle on top of shackle
KZ32CB1
spring and hold shackle in closed position.
KZ32CB2
(Figure 2)
KZ32CC0
Figure 2
KZ32DA0
KZ38BA1
KZ38BA2
KZ35EC1
KZ35EC2
KZ35EC3
KZ35EC4
3. While holding shackle closed, insert shackle
mounting screw in tapped hole and tighten with
CAM ID
an M2.5 Allen Wrench. Release shackle.
(Figure 3)
Figure 3
C1
C2
C1 C2
Key Retaining
Locking Cams*
4. Grease locking ball bearings. Insert two
locking ball bearings into lock body and move
into side pockets. (Figure 4)
Figure 4
HOUSING ID
1
2
2
Padlocks: Conventional Key-in-Knob – Key Retaining
Tapped Hole
5