Preparing The Remote Controller - DJI C2 Guía De Usuario

2. Linking
The aircraft and the remote controller are linked before shipment if you purchase
the Spark Combo (with the remote controller included). To link a remote controller
to Spark, follow the instructions below. Ensure the remote controller is within 0.66 ft
(20 cm) of the aircraft during linking.
Power on the aircraft and the remote controller. Wait until the
aircraft status indicators blink yellow.
Press and hold the power button of the Intelligent Flight Battery
for 3 sec. Release the button by hearing a single beep. Then the
front LEDs blink red.
Press and hold the Flight Pause button, the Function button, and
the Customizable button simultaneously. Linking begins when
the alarm becomes a quick single beep after an alternating
single/double beep.
Then the front LEDs turn solid red after blinking green. When the
status LED on the remote controller turns solid green, linking is
complete.
Apart from using the remote controller, you can control the aircraft using
virtual joysticks in the DJI GO 4 app. However, when the remote controller
is linked to the aircraft, virtual joystick control is disabled. You can enable
virtual joysticks by pressing and holding the power button of the Intelligent
Flight Battery for six seconds until hearing a double beep, which will
disconnect the remote controller and aircraft. Please refer to the Spark
User Manual for further information.

3. Preparing the Remote Controller

Unfold the antennas and
the mobile device clamps.
Connect the mobile device to the remote controller Wi-Fi network.
Spark_RC-xxxx
Power on the Connect to
aircraft and the the Wi-Fi.
remote controller.
4
Attach a mobile device.
DJI GO 4
App
Launch the Tap GO FLY to enter
DJI GO 4 app. the camera view.