Clg140/ Clg160 - With Spike - Monitor Audio CLIMATE GARDEN Serie Guia De Instalacion

CLG140/ CLG160 - With Spike

1 First screw the threaded section supplied
(i) onto the CLG140/ CLG160 speaker, once
secure thread the cables attached to the speaker
through the hole in the spike before attaching the
spike to the threaded section (ii).
3 Dig a shallow trench along the path of
where you wish to run the speaker cables.
NOTE: Ensure the system is tested and working correctly before filling in around the subwoofer and cable tenches.
2
4 Connect speaker's cables in parallel with
the main run of cable from the amplifier
combining all positive cable together and all
negative cables together.
To CLG140/
CLG160
From previous
speaker/ amp
opposite) or appropriate weather proof junction box
(not included).
Note: Ensure that no '-' and '+' strands are
touching each other as this will cause a short
circuit that could damage your amplifer.
monitoraudio.com
Once assembled, the speaker
can now be installed in the
desired location.
The pivot angle of the CLG140/
CLG160 can be adjusted using
an allen key.
Note: It is advised to hold the
speaker from the spike whilst doing
this so that no pressure is placed on
the pivoting section.
Connections
should be made
with either
silicone filled
wire connectors
To Next speaker
(example
3