Publicidad
Idiomas disponibles
Idiomas disponibles
5-4 CLEANING EVERY WEEK:
In addition to the daily cleaning, it is necessary to clean
every week the steam evacuation chamber and the cooking
chamber
NOTE: use the specifi c tools and cleaning product delivered with
the appliance for an effi cient and quick cleaning.
WARNING: The cleaning has to be done with the appliance
in high temperature to guaranty the effi ciency of the cleaning
product. Use gloves dedicated to high temperature.
- STEAM EVACUATION CHAMBER
1. Remove the front top cover (screwed button) and clean the
steam evacuation chamber using a damp cloth or a sponge
soaked with ECOLAB Rapid Grease (0S1195).
2. Rinse and dry with cloth.
Front top cover could be put into a dishwasher
IMPORTANT:
Check the complete cleanliness before to re-install the front
top cover
Be sure to have re-installed the front top cover before using the
appliance
Be sure that there is nothing (cloth, sponge, paper towel ...) left
inside the steam evacuation chamber
- COOKING CHAMBER
A cleaning instruction card «weekly 1/7» is also delivered with
the appliance.
Follow the procedure here below:
1- Turn off the unit.
2- Put a glass saver (eg cloth or high temperature silicone pad)
and maintain the lid closed.
6 - BRIEF TROUBLESHOOTING GUIDE
Even with correct use, malfunctions can occur. The table below is listing some
possible fi ndings.
FINDINGS
The appliance doesn't show the light below
the On/Off button
The lid doesn't keep closed when you are
in operating mode
The appliance shuts off unexpectedly
The unit display « - -»
The unit doesn't display anything but all
buttons light are blinking
The unit displays «Err1, Err2, Err3, Err4,
Err5, Err6»
In any case unplug the appliance and call the technical service agent whenever the appliance is not allowing to be used as
described in the operating instruction above.
Important: Service may only be carried out by a qualifi ed, trained and
authorised person.
HSG GB 06 2009
11B
WHAT TO DO
Verify if the appliance is plugged in the
socket and/or the circuit breaker is on
Check if the handle and the counter part of
the appliance are properly cleaned
Call the technical service agent
The appliance is either in cooling or in
preheating mode, please wait a reaso-
nable time
The appliance is in standby mode, to exit
it press any programme button
Call the technical service agent
10/11
3- Unlock the upper heating plate by pushing the unlocking
knob backward.
4- Help the descent of the upper heating plate by guiding the
fl exible tube.
5- Gently open the lid. The upper heating plate has to stand
up right on the glass saver.
6- Put a damp cloth all along the back area of the lid and metallic
frame.
7- Spray the cleaning product all inside the cooking chamber
with the delivered sprayer.
8-
Allow to soak for 1 minute. The cooking chamber must be
hot for a good effi ciency of the product.
9-
Scrub the surface of the cooking chamber with an abrasive
sponge or pad.
10- Wipe with a damp cloth.
11- Put in place the upper heating plate and push it to the highest
position until the «clic».
warning:
- The upper heating plate is hot: use protective gloves.
- Respect the right position of the upper heating plate: the
symbols must be in the front.
- Guide the fl exible tube to avoid damages.
12- Finish the cleaning by wiping the back of the lid and the
metallic frame. Remove the glass saver.
IF THE PROBLEM REMAINS
Call the technical service agent
Call the technical service agent
Call the technical service agent
Call the technical service agent
Publicidad
