Attaching Mounting Accessories - NEC MULTEOS M40 Manual De Instrucciones

Attaching Mounting Accessories

The display is designed for use with the VESA mounting
system.
1) Attach Mounting Accessories
Mounting accessories can be attached while the monitor
is on the Tabletop Stand in the upright position (Figure
1). Be careful to avoid tipping monitor when attaching
accessories. After accessories are attached, stand can be
removed (Figure 3).
Mounting accessories can be attached with the monitor
in the face down position. To avoid damaging the screen
face, place the protective sheet on the table underneath
the LCD. The protective sheet was wrapped around
the LCD in the original packaging. Make sure there is
nothing on the table that can damage the monitor.
When using mounting accessories other than NEC
compliant and approved, they must comply with the
VESA-compatible mounting method. NEC strongly
recommends using screws M6 size and 10mm in length.
If using screws longer than 10mm, check the depth of
the hole. (Recommended Fasten Force: 470-635N•cm)
NEC recommends using mounting interface that
comply with UL1678 standard in North America.
This device cannot be used or installed without the
Tabletop Stand or other mounting accessory for support.
For proper installation it is strongly recommended to
use a trained, NEC authorized service person. Failure
to follow NEC standard mounting procedures could
result in damage to the equipment or injury to the user
or installer. Product warranty does not cover damage
caused by improper installation. Failure to follow these
recommendations could result in voiding the warranty.
VESA Mounting Interface
Figure 1
Tabletop Stand
Figure 2
Table
English-7
Installation
- continued
Protective Sheet
Tabletop Stand