Safety Instructions; Principal Parts - Mosquito Magnet INDEPENDENCE Manual Del Operador

Safety Instructions

Please read and follow all safety
instructions and warnings.
Children and adults should be alerted to the
hazards of high surface temperatures and should
stay away to avoid burns or clothing ignition.
Young children should be carefully supervised when theyare in
the area of the heater. Keep out of reach of childr en.
Clothing or other flammable materials should not
behung from the heater, or placed on or near the
heater.
Note:
Some or all of the following required safety instructions
for propane powered devices may apply to your trap.
Allow trap to cool for 5 minutes before re-starting.
Warning:
Improper installation, adjustment, alteration,
service or maintenance can cause injury or property damage.
Read the installation, operating and maintenance instructions
thoroughly before installing or servicing the trap.
Caution:
The gas pressure regulator provided with this
appliance must be used. This regulator is set for an outlet
pressure of 11.0 in. Water Column. The minimum inlet gas
supply pressure is 11.0 in. Water Column from regulator.
• This unit is not intended to be installed in or on recreational vehicles and/or boats.
•
The gas supply must be turned off at the LP-Gas supply cylinder when
this appliance is not in use.
•
The installation must conform with local codes.
• To test for a gas leak, place soapy water around the connector,
regulator, and gas hose assembly. If bubbles appear, there is a gas leak.
• Inspect the hose before each use of the unit. If it is evident there is
excessive abrasion or wear, or the hose is cut, it must be replaced prior
to the unit being put into operation. The replacement hose shall be that
specified by the manufacturer.
• The trap is equipped with an internal spark. Failure to follow starting
procedure will result in the trap not starting.
• Installation and repair should be done by a qualified service person
(find service centers on www.mosquitomagnet.com).
• The heater should be inspected before use and at least annually by a
qualified service person. More frequent cleaning may be required as
necessary. It is imperative that the control compartment, burners, and
circulating air passageways of the heater be kept clean.
3
• Maintain adequate clearances of 50 cm - 60 cm around air openings
into the combustion chamber, clearances from combustible material,
provisions for accessibility and for combustion and ventilating air
supply. Keep the trap area clear and free from combustible materials,
gasoline, and other flammable vapors and liquids. The appliance is
not to be used in locations where flammable vapor or explosive dust
is likely to exist.
• Do not obstruct the flow of combustion and ventilation air.
• Keep the ventilating openings of the cylinder enclosure free and
clear from debris.
• Clean the trap with a water damp cloth, if necessary.
• The LP-Gas cylinder supply system must be arranged for vapor
withdrawal and the cylinder must include a collar to protect the
cylinder valve.
• The trap shall be used outdoors only in a well ventilated space and
shall not be used in a building, arage, or any other enclosed area.
• The LP-Gas cylinder must be disconnected and removed from the
appliance, if the appliance is stored indoors.
• LP-Gas cylinders must be stored outdoors in a well-ventilated area
out of reach of children.
• Disconnected cylinders must have threaded valve plugs tightly
installed and must not be stored in a building, garage, or any other
enclosed area.
• The pressure regulator and hose assembly supplied with this
appliance must be used for connection to the LP-Gas cylinder.
Replacement pressure regulators and hose assemblies must be
specified by the manufacturer.
• Avoid improper use of extension cords. Keep connections away from
moisture and avoid damage to the cord.
• If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid hazard.
• Do not store near heat or fire or where temperature may exceed
60°C.
• PPG Regulator and Hose Assembly Class A
• Rated Working Pressure: 2.74 kPa
Outlet Pressures: 2.50 kPa to 3.5 kPa
Velocity: 165 ft/min to 275 ft/min
Visit www.mosquitomagnet.com

Principal Parts

add regulator hose
Self-Contained
Independence ™
Regulator Hose (1)
Parts Included
Bug Bag
Quick Clear Adapter
Power Head (1)
Trumpet (1)
Support Pole (1)
Base Support (1)
4 "C" Batteries
"C" Size Batteries recommended:
- Micropower
- Panasonic Extreme Power
- Duracell Ultra
- Energizer Ultra +
4