Kohler K-99696-NA Guía De Instalación Y Cuidado página 13

Operation (cont.)
NOTE: If connected to a DTV+ system, the pin and device name
can be changed using the controller Web pages.
Upon receiving a wireless signal, the LED will turn solid blue and
the audio input will fade in.
Wireless input will override any signal that may be coming from
the front or back line-in ports.
3.5 mm Stereo Output
A line-out port is available to provide unamplified stereo output
of the audio signal that can be fed to another external device.
Standby Mode
If no audio signal is detected for 30 seconds from the 3.5 mm
line-in ports, the amplifier will go into standby mode and the
LED will turn yellow.
BLUETOOTH Standby: If no audio signal is detected for 30
seconds from a connected wireless device, the amplifier will go
into BLUETOOTH standby mode and the LED will change from
solid blue to blue blink.
DTV+ Operation
For information on operating the amplifier using the DTV+
system, refer to the guide on the K-99695 controller product page
at www.us.kohler.com.
Troubleshooting
IMPORTANT! Turn off the power supply before performing any
maintenance.
NOTE: For DTV+ system troubleshooting, refer to the guide on
the K-99695 controller product page at www.us.kohler.com.
NOTE: For service parts information, visit your product page at
www.kohler.com/serviceparts.
This troubleshooting guide is for general aid only. For service and
installation issues or concerns, call 1-800-4KOHLER.
Kohler Co. 13 1232038-2-B