User Information - aldes 11023226 Manuale De Montaje Y Usa

2. USER INFORMATION

A. Activation
If you received the remote control with your new heat recovery ventilation or air purification system, go directly to the 'Radio
pairing' paragraph.
If you received the remote control separately, with the radio antenna circuit board (PCB):
- Turn off the electricity at the mains,
- Open the Dee Fly Cube PCB access hatch (refer to the Dee Fly Cube installation notice),
- Discharge any static electricity by touching the casing of the Dee Fly Cube before touching the PCB, to ensure you do not
damage it, Insert the antenna PCB into the designated slot to the right of the keypad,
- Close the Dee Fly Cube PCB access hatch.
a) Radio version (pairing needed)
1. Turn off the HRV unit then turn it on again.
2. Present the radio remote control in front of the Dee Fly Cube unit and insert the batteries within two minutes (2 x type AAA 1.5V).
Or, if the Dee Fly Cube is already linked with a radio remote control:
1. On the HRV system, press and hold the filter and fan buttons together for three seconds.
2. Present the radio remote control in front of the Dee Fly Cube unit and insert the batteries within two minutes (2 x type AAA 1.5V).
Note: For wired use, no pairing is necessary between the system and the remote control.
Pairing in progress
17
Pairing successful