Alto Professional Stealth PRO Guia Del Usuario página 6

Connection Diagrams
Items not listed under
Example 1 – Mono Operation
To send mono signals through the Stealth Pro transmitter to a single receiver:
1. Connect your mixer's main output to an input on the Stealth Pro transmitter, and connect the
receiver's output to your loudspeaker's input. Keep all mixer volume and transmitter volume
controls at their minimum settings.
Note: When the transmitter is set to Mono, either input can be transmitted on both channels. This
allows you to adjust the signal levels being sent to separate zones, for example.
2. Power on the Stealth Pro transmitter and receiver. Set their channels to matching numbers. See
the instructions for using the Auto Sync function in
3. Adjust the transmitter and receiver antennas to a vertical position for best results in transmitting
the wireless signal. If the wireless signal quality is poor, change the position of the antennas.
4. Set the transmitter to Mono and adjust the Volume control to get a strong signal without clipping.
5. Turn on your loudspeaker, adjust the output level on your mixer, and adjust the Volume control
on the transmitter to hear the audio signal. If you hear noise in the signal, change to a different
channel until a clean signal comes through. See the instructions for changing the RF frequency in
Operation for more information.
6
Introduction > Box Contents
Power
Transmitter
Mixer
are sold separately.
Operation for more information.
Powered Speaker
Receiver
Power