Pt 40 Flexx Bodypack Transmitter; Controls - AKG WMS 40 FLEXX Modo De Empleo

BDA WMS 40 FLEXX 08_Hex:Layout 1
Refer to fig. 3 on page 2.
2.6 PT 40 FLEXX Bodypack
Transmitter

2.6.1 Controls

Refer to fig. 4 on page 2.
26
01/08/2008
2 Description
19 Color code clip: The color of this plastic clip indicates the carrier frequency band of
your transmitter. Re ceivers tuned to the same frequency band are marked with the same
color. Refer to the Manual Supplement sheet for a color code table.
You can remove the color code clip on the HT 40 FLEXX and replace it with the supplied
semitransparent clip.
20 Battery compartment lid: Refer to section 3.5.
21 Carrier frequency label: The label above the battery compartment indicates the name
of the carrier frequency band and the three carrier frequencies of your transmitter.
You can use the PT 40 FLEXX bodypack transmitter with both dynamic microphones and con-
denser microphones designed for a supply voltage of approx. 4 V. You may also connect an
electric guitar, electric bass, or remote keyboard.
Operating in the 660 MHz to 865 MHz UHF range, the PT 40 FLEXX provides three selectable,
quartz stabilized carrier frequencies within the 3-MHz-wide frequency band for which you ordered
your WMS 40 FLEXX.
22 On/off switch: This slide switch provides three positions:
ON: Power to the transmitter is on.
MUTE: The signal delivered by the microphone element is muted while power and the
RF carrier frequency remain on.
OFF: Power to the transmitter is off.
23 Status LED: Indicates the transmitter's operating status.
LED lit green: Battery is OK.
LED lit red: From the moment the LED changes to red, the battery capacity will provide
a maximum of two operating hours. We recommend replacing the battery with a new one
as soon as possible.
Note: • If you use a rechargeable battery, the LED will change to red 15 minutes before the bat-
tery will be dead!
24 Audio input: 3-pin mini XLR connector with both mic and line level pins that automat-
ically match the connector pinout of the recommended AKG microphones or MKG L gui-
tar cable.
While the MKG L guitar cable is included in the Instrumental Set (see section 2.2 Un-
packing), it is also available as an optional accessory.
25 Frequency selector: This slide switch tunes the transmitter to one of three different
carrier frequencies within the transmitter's carrier frequency band.
26 Antenna: Permanently connected, flexible antenna.
27 Belt clip for fixing the transmitter to your belt.
28 Battery compartment lid with integrated screwdriver (28a).
28b Viewing window: The viewing window lets you check if there is a dry or rechargeable
battery inside the battery compartment. You can also place a white lettering strip (sup-
plied) or a color code strip (optional) behind the viewing window.
29 GAIN: This rotary control inside the battery compartment allows you to match the body-
pack transmitter input gain to the microphone or instrument you connected to the trans-
mitter.
30 Carrier frequency label: The label on the transmitter rear panel indicates the name of
the carrier frequency band and the three carrier frequencies of your transmitter. Refer
to the Manual Supplement sheet for a color code table.
15:52 Seite 26 (Schwarz/Black Auszug)
WMS 40 FLEXX