Remote Controler'S Specifications; Introduction Of Function Buttons On The Remote Controller - kmk R101 Manual Usuario

1. REMOTE CONTROLER'S SPECIFICATIONS

Models
Rated Voltage
Lowest Voltage of CPU Emitting Signal
Reaching distance Signal range
Environment

2. INTRODUCTION OF FUNCTION BUTTONS ON THE REMOTE CONTROLLER

If the indoor unit has no this function, there is no corresponding operation happened when press the relative button on the
remote controller.
R101
TEMP. Button ▼: Press the button to decrease the indoor temperature setting.
TEMP. Button ▲: Press the button to increase the indoor temperature setting.
ON/OFF Button: Push this button to start the unit operation. Push the button again to stop the unit operation.
O2 / AIR CLEAN: Push this button to activate the oxygen generating mechanism, (if available), and the oxygen density of
indoor varies. To activate plasma filter (if available). Push again to stop the function.
MODE Select Button: Each time you push the button, a mode is slelected in a sequence that goes from AUTO COOL
DRY HEAT and FAN, as the following figure indicates:
FAN SPEED Button: SPEED Button: This button is used for setting Fan Speed in the sequence that goes from AUTO,
LOW, MED to HIGH, then back AUTO.
TURBO button: Turbo is used for all the residential units. In cooling mode, when pressing the turbo button the remote
controller (if available), the unit will enter Turbo mode, with ultra-high speed and reach the set temperature more quickly
(in this situation the speed of indoor fan will be higher that high speed level). After running 20 minutes in turbo mode, the
indoor fan will automatically recover the present speed. In heating mode, pressing this button will make nothing happen.
SWING Button: Push this button, the louver would swing up and down automatically. Push again to stop it.
SLEEP / ECONOMIC Button: Press this button to go into the Energy-Saving operation mode. Press the button again to
cancel.
10
R101, R51M/E
3.0 V (Alkaline dry batteries LR03 X 2)
2.0V
8 m (when using 3.0 voltage, it Gets 11 m)
-5°C ~ 60°C
TEMP button
ON/OFF button
O button
2
MODE select button
FAN SPEED button
TURBO button
SWING button
SLEEP button
AIR DIRECTION button
RESET button
TIMER button
CANCEL button
CLOCK button
LOCK button
LED DISPLAY button
R51M/E
SETTEMPERA TURE
( C)
FAN
AUTO
HIGH
COOL
MED
DRY
LOW
HEAT
TEMP
ON/OFF
MODE
FAN SPEED
TIMER ON
SLEEP
SWING
TIMER OFF
RESET LOCK
AIR
LDE
DIRECTION
DISPALY TURBO