Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY OF MOTOR UNIT
Disconnect tool from power source!
1.
In the hardware package, locate the two cap screws, two flat washers, and a
5/32" (4.0 mm) hex wrench. Place the washers on the cap screws.
2.
Insert the splined cutter shaft (Fig. 3) through the motor carriage (L) and into
the spiral grooved bushing (M) in the main frame (N). Orient motor as shown
in Fig. 8 and seat it into the motor carriage.
3.
Insert the two screw and washer assemblies (from Step 1) through the motor
carriage (Fig. 4). Thread them into the holes in the motor housing. Tighten
securely with the hex wrench.
L
N
Fig. 3
DETERMINE WIDTH OF CUT
Measure the width of the lock box at its widest point, including any protruding
parts. DO NOT INCLUDE THE LOCK FACE. Select a cutter equal to, or slightly
larger than this width.
Example: 1) Overall width of lock box – 31/32" (24.6 mm)
Use PORTER-CABLE #43704PC 1" (25.4 mm) diameter bit.
2) Overall width of lock box – 3/4" (19.1 mm)
Use PORTER-CABLE #43703PC 3 /4" (19.1 mm) diameter bit.
Various sizes of bits are available as accessories.
DISCONNECT THE TOOL FROM THE POWER SOURCE and
exercise extreme care when handling the cutter to avoid bodily injury or damage
to the cutting edge.
Thread the selected bit on the end of the splined cutter shaft. Tighten securely.
DETERMINING LENGTH OR HEIGHT OF CUT
Measure the height of the lock box (Fig.
5), including any protruding parts. DO
NOT INCLUDE THE LOCK FACE.
M
OPERATION
9
SCREWS & WASHER
Fig. 5
Fig. 4
Publicidad
Tabla de contenido
