Initial Settings; Autoscan - Sylvania 6626LCT A Manual Del Usuario

I
NITIAL SETTINGS
Hint: Before starting initial setup you must connect antenna.

INITIAL SETTINGS

This section describes the initial settings when you
first turn on the power after purchase. The initial
setting items are shown below.
• LANGUAGE SELECTION
You can select the menu language displayed on
the screen among English, Spanish and French.
• AUTOSCAN (TV/DTV)
(Select "Air" when using antenna)
The channels broadcasted in TV and DTV are
automatically scanned and memorized. Only the
receivable channels in the area where this TV is
used will be memorized.
• AUTOSCAN (CATV)
(Select "Cable" when using RF/Incoming cable)
The channels broadcasted in CATV are automati-
cally scanned and memorized.
POWER POWER
1
4
7
-
SETUP
BACK
1
After making all the necessary connections, turn
on this TV.
2
Press [POWER]. Initial Setup menu will appear.
• This operation may take a few moments.
• If initial setup menu does not appear press and
hold [ENTER] for 3 seconds initial setup will
appear then proceed to step 3 below. If you
have already turned on this TV before, refer to
"LANGUAGE SELECTION" on page 17 to
select a language for the on-screen displays.
12
EN
INPUT
SLEEP
SELECT
2 3
5 6
AUDIO
8 9
STILL
0
SCREEN
MODE
ENTER ENTER
INFO
3
Select your language using [ K / L ], press
[ENTER].
When you first turn on the power, the following
screen is displayed.
Initial Setup Initial Setup
Select the language used for setup.
Elija idioma de preparacion.
Selectionner langue ecran config.
Select
ENTER
The Antenna Confirmation will be displayed in
the selected language after you press [ENTER].
4
Select destination of RF In jack using [ K / L ],
press [ENTER].
Initial Setup Initial Setup
Make sure the antenna is connected to "ANT IN" jack.
Select the destination of "ANT IN" jack.
Air
Cable Or
Select ENTER Enter
5
Autoscan will start automatically.
Initial Setup
Initial Setup
Now the system is scanning for channels,please wait.
5%
Analog channels
Digital channels
• When scanning has completed, the lowest
memorized channel will be displayed.
NOTES:
• The initial Autoscan function can be executed for either "Air"
or "Cable" only once. When you change the connection
(Air/Cable), set the "Autoscan" again. (Refer to page 13.)
• When the scanning is not completed, Helpful Hint will dis-
played every time you turn on the power. If you have pre-
viously registered channels when this screen appears
you can select a channel with number buttons.
No channel is registered.
Press and hold "ENTER" key for 3 seconds.
Contact support hotline provided on manual or back of unit.
Sin canal registrado.
Mantenga oprimida la tecla "ENTER" durante 3 segundos.
Llame teléfono de apoyo en manual o atrás de TV.
Pas de chaîne consign.
Maintenir la touche "ENTER" pressée 3 secondes.
Contacter numero d'urgence dans manuel ou arrière appareil.
• Support hotline is provided on the front page of this
manual.
English
Espanol
Francais
SETUP
Enter Exit
Air
Cable
ANT IN
BAVK SETUP
Back Exit
1ch
0ch
SETUP
Exit
2-0