Publicidad
Idiomas disponibles
Idiomas disponibles
ALCAD
Start/on
Main menu
Select series
Transcodifi cador 912 QPSK - COFDM
NIT Table
Select series
PC-526 Channel processor
PC-527 Channel processor
905-PC Channel processor
Confi gure module
Set the programming switch of the 905-PC module to the ON position. The programming indicator
Mode
Digital
Input
Power preamplifi er Off
Program by
Channel
Channel table
BG CCIR
Channel
2
Frequency
57.50
Off set
0
Bandwidth
8
Status
Input level
Output
Program by
Channel
Channel table
BG CCIR
Channel
2
Frequency
57.50
Off set
0
14
Attenuation
Status
Set the programming switch of the 905-PC module to the OFF position. The programming indicator
QUICK PROGRAMMING GUIDE PC-526/PC-527
will now light up and remain lit.
OK++OK+T
MHz
MHz
MHz
OK++OK+T
Correct
Error
Corrrect
No signal/Excessive/
Inssufi cient
OK++OK+T
MHz
MHz
OK++OK+T
dB
OK++OK+T
Correct
Error
light will now go out.
Press the Power On key of the PS-011 to start up the
system.
OK
Choose Select Series to select the programming series.
Select the series: PC-526 Channel Processor or PC-
OK
527 Channel Processor.
To commence programming the module, select Confi gure
OK
module.
Select the operating mode. Then press T to transmit.
OK++OK+T
Select the Power preamplifi er On/Off. Then press
OK++OK+T
T to transmit.
Select the programming mode of the input of the
OK++OK
module: channel or frequency.
OK++OK
Select the standard for the input channel.
Keypad + T
Enter the input channel either by using the numeric
o
keypad or by selecting a channel from the pulldown
list. Then press T to transmit.
Use the numeric keypad to enter the frequency of the
Keypad + T
input channel. Then press T to transmit.
Select the offset of the input channel from the pulldown
Keypad + T
list. Then press T to transmit.
Keypad + T
Set the bandwidth of the output channel to 7 or 8
o
MHz. Then press T to transmit.
Status of the input; in grey if there is not information; in
green if the input is correct; and in red indicates error.
READ
Input level; in grey, if there is not information; in green,
if the level is correct; in red, if there is not signal, if the
signal level is excessive or it is inssufi cient.
Select the programming mode of the output of the
OK++OK
module: channel or frequency.
OK++OK
Select the standard for the output channel.
Keypad + T
Enter the output channel either by using the numeric
o
keypad or by selecting a channel from the pulldown
list. Then press T to transmit.
Use the numeric keypad to enter the frequency of the
Keypad + T
output channel. Then press T to transmit.
Select the offset of the output channel from the pulldown
list. Then press T to transmit.
Keypad + T
Enter the attenuation in the output of the module using the
o
numeric keypad. Then press T to transmit.
Status of the output; in grey if there is not information;
READ
in green if the output is correct; and in red and in red
indicates error.
Publicidad
