Publicidad
GB
EC - Declaration of conformity
The central gearmotors for rolling shutters series
RO
LLING comply with the following technical
standards:
UNI EN 292 Part I, UNI EN 292 Part 2, UNI EN 294,
UNI EN 418, CEI EN 60335-1, EN 55014-2 and the
European directives 98/37/EEC, 73/23/EEC, and
89/336/EEC.
Declaration of incorporation
The central gearmotors for rolling shutters series
ROLLING, when installed and maintained according
to
IMPORTANT SAFETY INSTRUCTIONS
ATTENTION - FOR REASONS OF PERSO-
NAL SAFETY IT IS IMPORTANT TO OB-
SERVE THESE INSTRUCTIONS
RETAIN THESE INSTRUCTIONS
Do not let children play with fixed con-
trol devices. Keep the remote controls
out of
reach of children Perform
fre-
quent checks on the system for any signs of unba-
lance and wear or damage to wires or springs. Do
not use the equipment if it requires repair or re-
gulation.
These warning symbols serve
to remind you to pay the maxi-
mum attention when the equip-
ment is in use.They indicate the procedures to be fol-
lowed to avoid risks to persons or things. This gear-
motor is designed to function safely if installed and
used in compliance with the following instructions.
The equipment must only be employed for
resi- dential uses and must be installed indoors.
You are warned that incorrect instal-
lation can cause serious injuries.
Follow all the installation instructions.
the manufacturer's instructions, in
with roller rolling shutter, which must also be in-
stalled and maintained according to the instruc-
tions of their manufacturers, comply with the pro-
visions of the regulations of the EU Directive
89/392 EEC and successive amendments.
I the undersigned declare that the foregoing equip-
ment and all the accessories stated in the handbook
comply with the foregoing directives.
Do not use command buttons that
can simultaneously operate the equip-
ment in both directions. Do not com-
mand more than one gearmotor with each but-
ton. Conduct frequent examinations on the in-
stallation to check for signs of unbalance and
wear/damage to the wiring. Do not use the
equipment if it requires repairs or adjustments.
The product cannot be installed for heights
of less than 2.5. m.
The deployment of a device that guarantees om-
nipolar disconnection from the mains with
an opening of at least 3 mm between the
contacts is obligatory.
Before installing the gearmotor for operating
the rolling shutter remove all superfluous wires
and disable any equipment not necessary for
motorised movement. The control button must
be placed in sight of the equipment, kept sepa-
rate from the moving parts and at a height of at
least 1.5 m.
If the power cables are damaged they must be re-
placed by the constructor or his technical after-sa-
les service or, in any case, by a similarly qualified
person in order to avoid all risks.The gearmotor is
designed for intermittent operation and is provi-
ded with an internal thermal protection that inter-
rupts power supply in the event of overheating
caused by continued use.The gearmotor automati-
cally resets itself after a few minutes. However, re-
gular operation will only be possible when
the gearmotor cools down.
conjunction
Publicidad
