Spare Parts; Specifications; Troubleshooting - IRIS IC-FAC2U Manual De Instrucciones

ABOUT SPARE PARTS
Please purchase replacement parts from IRIS USA, Inc.
Dust Cup Mesh Filter, (2 PC)
Should be replaced every 6 to 12 months depending on frequency
of use. If broken or damaged, please replace.
Model number: CF-FS2
Exhaust Filter, (2 PC)
Should be replaced every year. If broken or damage, or if poor
ventilation or abnormal odors occur, please replace.
Model number: CF-FH2
IRIS USA, Inc.
13423 West Cactus Road
Surprise, AZ 85379
www.irisusainc.com

SPECIFICATIONS

Before making repairs, please read the following content carefully to fix common problems.
Vacuum, dust cup and filter (included in unit), exhaust filter (included in unit),
ITEMS INCLUDE
and cord band (included in unit).
OPERATING: 9.8in x 19.1in x 8.3in / 250mm x 459mm x 212mm
Product Size (in/mm)
STORED: 9.8in x 65.7in x 15.9in / 250mm x 144mm x 403mm
Product Weight
About 3.5lbs/1.6kg
Power Cord Length
13.1ft/4m
Rated Voltage
120V
Frequency
60Hz
Ampere
3.8A
Capacity
0.21qt/0.2l
*Specifications are subject to change without prior notice.
9

TROUBLESHOOTING

Before making repairs, please read the following content carefully to fix common problems.
STATUS
Low suction
Filter is clogged.
Abnormal heating
Dust cup is clogged.
Filter is clogged, automatically turning
power to LOW to prevent overheating.
Blinking operation light,
Depending on the operation mode,
low suction
the humidity of the room, and the
environment, the operation light may
flash and decrease the power.
Not running, but dust sensor is on
Sensor is coated in dust.
Running, but dust sensor is off
Significantly lower suction.
Plug is not inserted into the outlet
correctly.
Stop operating
"Protection mode" has been activated
to prevent overheating.
Hot air not heating
Room temperature is too low.
Protection Mode:
If you continue to use product without emptying the dust cup and cleaning the filter, protection mode will
activate to prevent overheating of the motor. The operation light blinks even if the power is turned on.
The vacuum motor will temporarily shut down.
Solution:
1. Turn off the vacuum. Unplug from the outlet.
2. Empty the dust cup and clean the filters.
3. Place in a cool location.
After about an hour, protection mode will be unlocked and product can be used again.
Problems that could not be resolved.
Please contact the dealer of purchase or IRIS USA, Inc. customer service.
Warning: Do not disassemble, repair or modify the product yourself. Any other servicing should be performed by an
authorized service representative.
POSSIBLE CAUSE REMEDY
Please clean or replace.
Please remove dust.
Please clean or replace.
Please remove dust.
Please clean sensor (p7).
Please clean or replace filter, and empty
contents from the dust cup.
Reinsert the plug and press the menu
button.
Follow the "protection mode"
instructions carefully.
Use in cooler rooms or use on LOW may
take longer to produce hot air.
10