Operation Mode; Power Off Mode; Power On Mode; Cloning - Maxon CIC Europe S5 Manual De Usuario

User Manual

Operation Mode

This section provides general descriptions of the operating modes of the S5 Radio.

Power off Mode

The S5 shall enter Off mode when the On/Off Volume knob is rotated to the most counter-
clockwise position, beyond the detent. Upon entering off mode, the radio shall store its current
channel (if Power On Channel function is enabled via PC Programmer).

Power on Mode

The S5 shall enter Power-On mode when the On/Off Volume knob is rotated clockwise beyond the
detent. Upon entry of the Power-On mode, the radio shall perform the 1 time power-on alert to
indicate that it has been turned on.

Cloning

Frequencies and functions can be programmed from radio to radio by using a cloning cable.
Cloning cable 3.5mm to 3.5mm stereo jack plug
1. Connect Cloning cable 3.5mm to 3.5mm stereo jack plug to radios
2. Slave radio Press and hold "Monitor + PTT" buttons together and switch on power.
3. Master radio Press and hold "Emergency + PTT" buttons together and switch on power.
Slave radio when switched on with Monitor + PTT" buttons pressed together will give flashing
orange LED.
Master radio when switched on with Emergency + PTT buttons pressed together will give
flashing orange LED. When cloning is complete both radios LED will go solid green.

Password

If the password function is enabled, (dealer programmable) the user must enter a password for the
radio to become operational. At this time you can enter the password code by using the
EMG/PTT/MON/OPTION button in the correct sequence. Four button presses are required to enter
the code. If the code is not correct, the LED will blink red and there will be a double beep repeated.
To disable the password function radio must be reprogrammed by an authorised Maxon dealer.
Page 12
S5