Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1 ON/OFF "O" - a short press
f
f
1 "P" to select the programs - a short press
f
f
2 "+/-" keys per output, in each side of the LCD display, to adjust the intensity of the stimulation.
f
f
A long (1 sec.) press on the "-" key allows to return the power level rapidly to zero.
F UNCTION 1 - "ON / OFF" SWITCH
1
A short press on the "O" key puts the device under or off power.
f
f
Every time under power, the device makes an auto-test on 11 essential parameters at the level of the safety of its operation.
f
f
During the auto-test segments and pictograms are lit during 0,5 second.
If an internal defect in the device is detected, all the pictograms flash. Send back the device to the After Sale Service.
f
f
The auto-test does not take into consideration the used batteries. When the batteries are used the autotest cannot be performed.
f
f
One long press (over 3 sec) on the "O" key stirs up the auto-test.
f
f
In this case, stop the device by pressing the "O" key and then press shortly the "O" key again.
F UNCTION 2 - CHOICE OF A PROGRAM "P"
2
Just make one or several presses on the "P" key, the programs ravel.
The programs are announced by numbers from 1 to 4.
Once the program is chosen, the program number is shown on the display. (see page 10).
Once the program is chosen, you can start it by increasing only one of the both "+"keys.
During the program the "P" key is inactive.
F UNCTION 3- END OF PROGRAM - STOP
3
At the end of the program the device stops automatically.
f
f
To stop the device during a program, you just have to turn 2 power keys to zero or to press the "O" key.
f
f
In case of emergency, press the "O" key.
f
f
F UNCTION 4 - ADJUSTMENT THE POWER
4
You have 64 levels from 0 to 64 to adjust the electro-stimulation power.
Between two segments, there are 7 power levels or 4 short press on "+" key.
F UNCTION 5 - BATTERIES
5
If the batteries are "good", there is no blinking.
f
f
If the batteries are "weak", two segments (the 6th segment) blink (scheme page 10). Your device still works.
f
f
If the batteries are "used", two segments (the 10th segment) blink (scheme page 10).
f
f
If your device stops, even during a program: change the batteries.
f
f
F UNCTION 6 - DISCONNECTION
6
Your device is endowed with an accessory disconnecting detector.
If there is no contact between the skin and the accessory, the power is stopped on the concerned output (channel A or B).
You are warned of the disconnection by blinking of the 1st segment during 30 sec., after 30 sec. the blinking stops (diagram, page
10).
If no accessory is in contact with the body, the power cannot be emitted.
III. USE THE MULTIFUNCTIONAL BELT
The multifunction belt can be used whole, or separated into 2 to form 2 half-belts.
The full belt must be used on the stomach, buttocks, lower back areas.
Once unfastened, the 2 "half-belts" can be used on the arms, thighs, or calf.
The multifunction belt has built-in electrodes on which the SPORT-ELEC® cream is applied.
This cream enhances contact between the electrodes and the skin.
Its massaging and electro conducting properties improve comfort of use and enhance stimulation.
The cream can also be used for body massage.
If you want to buy the SPORT-ELEC® cream, please order directly by going on www.sport-elec.com, or contact your local supplier.
WARNING!
Never use the belt without the cream provided.
f
f
Do not use any cream other than the one provided by SPORT-ELEC® INSTITUT.
f
f
- USER MANUAL
11
Publicidad
Tabla de contenido
