Troubleshooting - DIAL 9K Manual Del Usuario

Troubleshooting

The following cases may not always be a malfunction, please check it before asking for service.
Trouble
Does not run
No cooling or
heating air
Ineffective control
Does not operate
immediately
Peculiar odor
A sound of
flowing water
Cracking sound is
heard
Spray mist from
the outlet
The running indicator flashes on constantly,
and indoor fan stops.
Mode interference
Because all indoor units use the same outdoor unit and
the outdoor unit can only run with one mode of
operation at a time (cooling or heating), mode
interference will occur when an indoor unit is set to a
different operating mode than the operating mode of
the outdoor unit and other indoor units. The following
shows the mode interfere scene.
don't run
17
Analysis
If the protector trip or fuse is blown.
Please wait for 3 minutes and start again,
protector device may be preventing unit to work.
.
If batteries in the remote controller exhausted.
If the plug is not properly plugged.
Is the air filter dirty?
Are the intakes and outlets of the air
conditioner blocked？
Is the temperature set properly？
If strong interference(from excessive static
electricity discharge, power supply voltage
abnormality)presents, operation will be
abnormal. At this time, disconnect from the
power supply and connect back 2-3 seconds later.
Changing mode during operation, 3 minutes
will delay.
This odor may come from another source
such as furniture, cigarette etc, which is
sucked in the unit and blows out with the air.
Caused by the flow of refrigerant in the
air conditioner, not a trouble.
Defrosting sound in heating mode.
The sound may be generated by the expansion
or contraction of the front panel due to change
of temperature.
Mist appears when the room air becomes
very cold because of cool air discharged
from indoor unit during COOLING or DRY
operation mode.
The unit is shifting from heating mode to defrost.
The indicator will flash within twelve minutes and
returns to heating mode.
cooling dry
cooling
dry
heating
fan
The outdoor unit will always run according to the mode of first indoor unit
that is turned on. When the setting mode of one of the other indoor units
causes mode interference, 3 beeps will be heard, and the indoor unit that
caused the interference will turn off automatically.
heating
fan
normal
mode interfere