Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SETUP INSTRUCTIONS
INSTALL BATTERIES
The VIC's battery compartment is behind a hinged door on the front of the pistol grip
(Fig. 1, Callout 6).
1. Open the battery compartment by using a Phillips-head screwdriver to loosen the single
screw securing the compartment cover near its top. Swing the hinged door down.
2. Extract the battery magazine by pulling on the black tab at its bottom.
3. Install the four included "AA" batteries in the magazine, orienting them according to the
polarity diagrams inside. Push the magazine back into the grip (it fits only one way).
4. Swing the compartment door up to close it.
5. Secure the compartment cover by reinstalling and tightening the Phillips-head screw.
INSTALLING ACCESSORIES
The VIC comes with three accessories (see left photos below) in a Ziploc bag that attach to the
camera-tipped end of the probe. Each accessory has a specific purpose:
• The 45° mirror lets the probe see around corners.
• The pickup hook lets you retrieve otherwise inaccessible items seen by the camera —
for example, a wedding ring accidentally dropped down a sink drain.
• The magnetic pickup lets you retrieve lost or dropped metal objects—nuts and bolts,
for example—located by the probe.
To attach an accessory to the VIC's probe,
1. Hold its metal stem with your thumb and index finger.
2. Slide the accessory—plastic clasp first—past the camera head at the probe tip until
the clasp is in the channel 1/4 in. from the end of the probe.
3. Squeeze the clasp until you hear a click (see top right photos below), indicating that the
two halves have joined.
To detach an accessory from the VIC's probe,
1. Use the nail of your index finger to unhook the clasp, opening it up.
2. Hold the accessory's metal stem with your thumb and index finger and slide the
accessory and clasp past the camera head.
3. Put the accessory back in the Ziploc bag it came in.
The VIC's three snap-on
probe-tip accessories
5
Publicidad
Capítulos
Tabla de contenido
