Grandstream HT818 Guia De Inicio Rapido página 4

HT818 PORTS
Port Description
Power socket. Used to power HT818 (12V - 1.5A)
Network LAN port. Used to connect your HT818 to
local network when using as router.
Network WAN port. Used to connect HT818 to your
router or gateway using an Ethernet RJ45 cable.
FXS ports to connect analog phones / fax ma-
chines to HT818 using RJ11 telephone cable.
Factory reset button. Press for 7 seconds to reset
to factory default settings.
CONNECTING THE HT818
The HT818 is designed for easy configuration and easy installation, to
connect your HT818, please follow the steps below:
1. Insert a standard RJ11 telephone cable into the phone port and con-
nect the other end of the telephone cable to a standard touch-tone ana-
log telephone.
2. Insert the ethernet cable into the internet or LAN port of the HT818
and connect the other end of the ethernet cable to an uplink port (a
router or a modem, etc.)
3. Insert the power adapter into the HT818 and connect it to a wall outlet.
4. The Power, Ethernet, and Phone LEDs will be solidly lit when the
Phone Adapter is ready for use.
3
CONFIGURING THE HT818
The HT818 can be configured either using the embedded Web
GUI using PC's web browser or using the IVR voice prompt menu.
Obtaining the IP address
The HT818 is by default configured to obtain the IP address from DHCP
server where the unit is located. In order to know which IP address is
assigned to your HT818, you should access to the "Interactive Voice
Response Menu" of your adapter via the connected phone and check its
IP address mode.
Please refer to the steps below to access the interactive voice response
menu:
1. Use a telephone connected to phone 1-8 port of your HT818.
2. Press *** (press the star key three times) to access the IVR menu and
wait until you hear "Enter the menu option ".
3. Press 02 and the current IP address will be announced.
Configure using Web UI
1. Connect the computer to the same network as your HT818 and make
sure the HT818 is booted up.
2. You may check your HT818 IP address using the IVR on the con-
nected phone.
3. Open the Web browser on your computer.
4. Enter the HT818's IP address in the address bar of the browser.
5. Enter the administrator's password to access the Web Configuration
Menu. (By default the admin password is admin)
Note: The computer must be connected to the same sub-network as the
HT818. This can be easily done by connecting the computer to the same
hub or switch as the HT818.
Please download the user manual and FAQ for more detailed configura-
tion instructions: http://www.grandstream.com/our-products
4