GE Profile ADVANTIUM PSA9240 El Manual Del Propietario página 31

Care and Cleaning
Removing and Cleaning the Filters
1. The metal filters trap grease released by foods on the
cooktop. They also prevent flames from foods on the
cooktop from damaging the inside of the oven.
when the hood is used. The vent filters should be
cleaned once a month, or as needed.
3. To remove, slide them to the rear using the tabs. Pull
down and out.
Replacing the Oven Cavity Lamp
1. Disconnect power at the main fuse or circuit breaker
panel.
2. Remove the top grill by removing the two screws that
hold it in place.
3. Remove charcoal filter if present. Slide the filter
toward the left and pull toward the front to remove.
NOTE: Charcoal filter is an optional kit, you may not
have one.
4. Remove the screw holding the lamp shield in place.
Charcoal Filter (JX81D - optional kit)
If the model is not vented to the outside, the air will be
recirculated through a disposable charcoal filter that
helps remove smoke and odors.
The charcoal filter cannot be cleaned. It must be
replaced. Order Part No. JX81D-WB02X10943 from your
GE Appliances supplier.
The charcoal filter should be replaced when it is
noticeably dirty or discolored (usually after 6 to 12
months, depending on usage).
49-40678-3
4. To clean the vent filters, soak them and then swish
around in hot water and detergent. Don't use
ammonia or ammonia products because they will
darken the metal. Light brushing can be used to
remove embedded dirt.
5. Rinse, shake and let dry before replacing.
6. To replace, slide the filters into the frame slots on the
back of each opening. Press up and to the front to
lock into place.
5. Pull the lamp shield out. Pull the light bulb out and
replace with the 120V-130V, 20-watt halogen bulb.
Order WB25X10019 from your GE Appliances
supplier.
6. Return the lamp and lamp shield to original position
and replace screw and charcoal filter.
7. Replace the grill and 2 screws. Reconnect power to
the oven
To install a new filter:
1. Remove plastic and other outer wrapping from the
new filter.
2. Remove the top grill by removing the two screws that
hold it in place.
3. Insert the filter into the top opening of the oven as
shown.
4. It will rest at an angle on two back support tabs and in
front by two tabs.
5. Replace the grill and two screws.
To remove the filter, repeat step 2 above, remove the
filter and repeat step 5.
31