Bushnell TRAILSCOUT 119833 Manual De Instrucciones página 11

(4) SET PASSWORD (cont.):
The LCD will show [Password Yes]. to change the password, press Enter.
Password
if you do not want to set a password, you can press the Up or Down key to select NO.
Yes
if you selected YES, the LCD shows [New Pswd]. Press the Up or Down key to select the
first password digit of 0-9. Press ENtER to confirm, the cursor will move to the next digit
New Pswd
to the right. Repeat the process using UP, Down and Enter keys to enter your four digit
0 0 0 0 password. Press ENtER to confirm.
if you do not want to set a password when the LCD shows (PW YES) , you can press the
U/D button to select No, After pressing the ENtER, the LCD display shows (PW NO),
Password
and no password will be set.
None
When you are finished with SEtUP, change K1 to the ON (UP) position and the unit will
be operating after a 2 minute delay.
(5) SET DAY TIME: (Note: This setting determines the time period when photos are taken in both
DAY and NIGHT only modes, and auto switches an infrared filter-see #4 under "Other Setup Notes")
When the LCD shows (Day time), press ENtER key to set the DAY tiME range. The
LCD will show and underscore under the first 2 digits in the DAY tiME mode. Press
the up or down keys to set time of 24 hour clock for the specific DAY tiME start hour
Day time
desired. Press ENtER to set the DAY tiME start time.
07 -- 18
Then, underscore will move to the second 2 digits in the DAY tiME mode. Press the up
or down keys to set time of 24 hour clock for the specific DAY tiME end hour desired.
Press ENtER to set the DAY tiME end time.
Now your DAY tiME is defined (NiGHt is defined as the period between DAY end and
start times). if you do not make your own settings for DAY, a default of 6AM~6PM is
used.
Example: 07—18 would define DAY as from 7AM to 6PM (6PM=18:00 hours on 24 hr clock).
Setup Guide (cont.)
11