Craftsman professional PYT9000 El Manual Del Propietario página 22

.
Toplacethe newbelt, begin by routingthe belt aroundthe two
outerspindlepulleysas shownin Figure15.
CUTTING BLADES
Shutthe engineoff and removeignitionkey beforeremovingthe
cuttingblade(s)for sharpeningor replacement. P rotectyourhands
usingheavy gloveswhengraspingthe blade.
Figure15
6. Thenroutethe beltaroundthe two deck idler pulleysas shownin
Figure15.
7. Retightenthe belt keeperrodloosenedearlier.
8. Remountthebelt guardsremovedearlier.
9. Reinstallthe deckas follows:
a. Withthe deck beneaththe mowerframe,attachthe stabilizer
rod. See Figure13.
b. Reconnectthedeck lift arms.See Figure12.
10. Pull the rightside ofthe beltand placethe narrowV side of the
belt intothe PTOpulley.See Figure16.
!ey
PTOBelt
Periodically inspectthe blade and/orspindlefor cracksor damage,
especiallyafter you'vestrucka foreignobject.Do notoperatethe
machineuntil damagedcomponentsare replaced.
To removethe blades,proceedas follows:
1. Removethe deck from beneaththe tractor,(referto CuttingDeck
Removal e arlierin this section)then gentlyflip the deck overto
exposeits underside.
2. Placea block of woodbetweenthe centerdeck housingbaffle
and the cuttingbladeto act as a stabilizer. S ee Figure17.
Figure17
3. Removethe hexflangenut that securesthe bladeto the spindle
assembly.See Figure17.
J
Figure16
11. Whileholdingthe beltand pulleytogether,rotatethepulleyto the
left (See Figure16).Continueholdingand rotatingthe pulleyand
belt untilthe beltis fully rolledinto the PTOpulley.
12. Replacethe PTOpulleybelt guard.See Figure10.
22