Maintenance - Husky H4840GHVSG Manual Del Usuario

Maintenance

Ensure the air line is shut-off and drained of air before removing this tool for service . This will prevent the tool from operating if the throttle
is accidentally engaged .
DAILY CLEAN UP
NOTE: Clean the spray gun immediately after use .
□ Remove and empty the canister . Rinse with a solvent recommended
for the paint or other material used . Refill the canister with clean solvent and
attach to the gun . Spray the solvent through the gun while shaking the gun vigorously .
Wipe the gun exterior with a solvent soaked rag . Repeat until the gun is clean .
□ Remove the air cap and soak in solvent until clean . Use a small brush for stubborn
stains if necessary . Toothpicks or small brushes may be used to clean air passages .
NEVER USE METAL OBJECTS TO CLEAN PRECISELY DRILLED PASSAGES .
DAMAGED PASSAGES WILL CAUSE IMPROPER SPRAYING .
□ Clean the gaskets with a solvent soaked rag . To prevent equipment damage, DO NOT
IMMERSE THE GASKET OR SPRAY GUN BODY IN SOLVENTS .
□ After using water to clean out water based paints or materials, spray mineral spirits
through the gun to prevent corrosion .
□ Use a non-silicone oil on all moving parts when reassembling . Use Vaseline®
or light grease on all threaded connections prior to storage .
8