Starting The Cleaner - Kruger FTX13011PRO Instrucciones Para El Uso

The electric power cable must never be under mecha-
nical tension and must be protected against accidental
crushing.
The use of any electric appliance requires the respect
of some basic rules:
- Do not touch the appliance with wet or damp hands
or feet.
- Do not use the appliance bare-footed or with
unsuitable clothing.
- Do not pull the supply cable or the appliance itself
in order to disconnect the plug from the electric
supply. (For water cleaners rated at less than 3
kW fitted with plug).
In case of damage or malfunction, switch off the
appliance (disconnecting it from the water main and
from the electricity main via the omnipolar switch or
by unplugging the plug in the case of water cleaners
rated at less than 3 kW)
Apply to one of our technical service cen-
tres.
Failure to observe the above warning frees
the manufacturer from all responsibility and
constitutes negligent use of the product.
USING THE CLEANER
CONTROL PANEL
A - On/off switch
B - Detergent control tap (if available).

STARTING THE CLEANER

1) Turn on the water supply tap (fig. 8A).
2) Connect the water cleaner to the mains electricity
supply via the omnipolar switch or by plugging the
plug into the socket.
3) Start the water cleaner with the ON/OFF switch
in the "I" position (fig. 10A).
The high pressure water jet generates a reaction force
in the lance. Keep a firm grip on the lance handle.
4) Press the trigger on the gun and begin washing.
In water cleaners with the "Total Stop" system, the motor
starts and stops when the lever on the lance handle is
actioned or released.
Do not block the handle lever in the delivery position.
IMPORTANT!
To eliminate any impurities or air bubbles
from the water circuit we advise starting
the cleaner for the first time without the
lance and letting the water run out for a
few seconds.
Impurities could block the nozzle and cause
malfunction (Fig. 11).
STOPPING THE CLEANER
1) After using with detergent, flush out the intake circuit;
place the detergent suction hose (fig. 12) in a tank of
clean water and let the pump run for 1 minute with the
dosing tap turned fully on and the lance in detergent
delivery condition.
2) Stop the water cleaner with the ON/OFF switch in
the "O" position (fig. 10A).
3) Discharge the pressure from the H.P. hose by pres-
sing the trigger on the gun.
4) Disconnect the water cleaner from the mains electri-
city supply via the omnipolar switch or by unplugging
the plug from the socket.
5) Turn off the water supply tap (fig. 8A).
If the water cleaner is left, even temporarily,
turn it off by using the omnipolar switch or by
unplugging the plug from the socket.
Water cleaners with the "Total Stop" device should
be considered as off when the omnipolar switch is in
the "O" position or the plug is unplugged from the
socket.
When the water cleaner is not used, close the safety
device on the handle (fig. 13).
Dry use of the water cleaner causes serious damage
to pump gaskets.
15