Rhin-O-Tuff OD4012 Manual De Instrucciones página 10

Removing Punch Pins
Turn machine power off and remove die
?
assembly from the machine.
On the opposite side of the die assembly from

the die handle,
Pull the pin capture away from the pin retainer
?
to expose the punch pins.
Remove the desired punch

pin or pins.
Replace the pin capture by pressing down on the pin retainer and

placing the pin capture back into place.
Install die assembly into machine as described earlier and turn
?
machine power back on.
Die Maintenance
Die maintenance should be performed with the die removed from the
u
machine. To perform the die maintenance, remove the die assembly
from the machine (see die installation section). Apply enough oil to
lightly coat each pin.
Remove any excess oil with a disposable cloth. After oiling, always
u
punch some scrap paper to remove excess oil.
Saturate a small section of a
cloth with oil and using that
portion of the cloth, wipe the
punch pins to apply a light
coating of oil.
push down on the pin retainer .
8