MTX Audio ROAD THUNDER Manual De Instrucciones página 7

SPECIFICATIONS
• Maximum Input Level: 15V RMS
• Maximum Output Level: 13.5V Peak
• Frequency Response: 10Hz - 100KHz
• THD: 0.003%
• Signal to Noise Ratio: -130dB
• Balanced Input Noise Rejection: >60dB
• Input Impedance: 10KΩ
• Output Impedance: 150Ω
• Power Supply: High Headroom PWM
• Power Draw: 150mA
• Recommended Fuse Rating: 1 Amp
TROUBLESHOOTING
The unit does not turn on and / or the power indicator LED is not illuminated:
1. Make sure that the B+ and GND wires are not reversed.
2. Make sure that all power wires are properly connected and have the appropriate potential
(11-16V).
3. Make sure that all fuses are intact.
Experience high audible distortion or low output volume:
1. Make sure that the input and output levels are set correctly. The input should match the source
and the output should match the sensitivity of the host.
2. Make sure that the crossover settings are correct. For high "Q" systems, set the crossover half
an octave above the desired point. For low "Q" systems, set the crossover one octave or more
above the desired point.
Experience whining or engine noise:
1. Make sure that the GND connection is secure and that the conductor (wire) is not too thin and
unnececessarily long.
2. Make sure that the B+ wire is not too thin and unnecessarily long.
3. Change the power source. Try taking power from a different point.