Start-Up Information; Preparing Your Hard Drive(S) For Use - Belkin F5U198ea Manual De Usuario

4. Using the provided serial ATA data cable, connect your serial ATA hard disk to one
of the ports on the PCI Card.
5. Use the provided serial ATA power cable adapter to connect the SATA hard disk to
your computer's internal power supply.
Turn on your computer. Shortly after the POST (Power On Self Test) is completed,
the following screen will be displayed:
Silicon Image 3112 SATARaid Yes Controller BIOS Version xxx
Copyright
Press <Crtl+S> or F4 to enter RAID Utility
Primary Channel: ST380023AS
Secondary Channel:
1. If you wish to set up a RAID Array, press "Ctrl+S", or press the F4 key.
2. Properly connected serial ATA hard drives will be displayed
(in this case an 80-Gigabyte Seagate ST380023AS on the Primary Channel).
3. After your serial ATA hard drive(s) are detected, the boot procedure will continue.
If you are installing new unformatted hard drives, the drives will need to be partitioned and
formatted before use. The F5U198 installation CD includes a detailed manual in PDF form that
walks you through each of the steps required to prepare your hard disk for use. The manual
also explains in detail how to set up and manage a RAID array. To access the manual, choose
the "SATARaid Utility Manual" button on the F5U198 installation CD start-up menu.
22ea_F5U198ea_Man.indd 5
©
1997-2002 Silicon Image, Inc
76819 MB

Preparing your Hard Drive(s) for Use

Hardware Installation

Start-Up Information

1
2
3
5
29/6/05 9:26:36