Cleaning And Disinfection; Troubleshooting; Disposal - Ohio Medical Push-To-Set PISA Instrucciones De Uso

EN

Cleaning and Disinfection

Routine cleaning of the regulator is recommended as a standard procedure after each use.
Wipe all exterior surfaces with a solution of water and mild detergent and/or an approved cleaning solution.
Approved Cleaning Solutions
• Sodium Hypochlorite 0.5% (Bleach): Mixture of 13 fl. oz. of bleach to 1 gallon (128 fl. oz.) tap water
• Isopropyl Alcohol 70%
• Hydrogen Peroxide 3%
• Cavicide Ready to use full strength
®
WARNING After patient use, regulators may be contaminated. Handle in accordance with your
hospital's infection control policy.

Troubleshooting

If the regulator does not operate and you have performed the Pre-Use Checkout Procedure, remove the
regulator from service and refer to PTS-ISU service manual or refer servicing to qualified service personnel.
Timing Cycle Adjustment
For timing cycle adjustment, refer to PTS-ISU service manual, section 7.
Installation Procedure for Adapters/Probes and Fittings
For adapter/probe installation, refer to PTS-ISU service manual, section 8.6.

Disposal

Digital Product Only: The batteries and circuit board are not suitable for regular trash disposal.
Follow local guidelines for disposal of other components.
Device may contain bio-hazardous material and should be disposed of properly. Follow local
guidelines for disposal of bio-hazardous material.
10
Cleaning and Disinfection
8700-0009-000 (Rev. 16) 10/2020