Tabla de contenido
Publicidad
Removing the power connector port
1.
Follow the procedure in
2.
Remove the:
a.
base cover
b.
battery
c.
dock frame
3.
To remove the power connector port:
a. Remove the screw to release the metal bracket on the power connector port [1].
b. Lift the metal bracket from the computer [2].
c. Remove the power connector port from the computer [3].
d. Disconnect the power connector port cable from the computer [4].
Installing the power connector port
1.
Insert the power connector port into the slot on the computer.
2.
Place the metal bracket on the power connector port.
3.
Tighten the screw to secure the power connector port to the computer.
4.
Route the power connector port cable through the routing channels.
5.
Connect the power connector port cable to the connector on the system board.
6.
Install the:
a.
dock frame
b.
battery
c.
base cover
7.
Follow the procedure in
Extracción del teclado
1.
Siga los procedimientos que se describen en
2.
Extraiga:
14
Before working inside your
After working inside your
Antes de manipular el interior del
computer.
computer.
equipo.
Publicidad
Tabla de contenido
