Adjustments - BH EMOTION Manual Del Usuario

7. Adjustments

The user can access the adjustments menu by pressing buttons (+) and (-) for 3 seconds. Press the POWER button to
scroll through the adjustments options:
The system will exit the "Adjustments" menu when the user presses the POWER button for 3 seconds.
7.1. Selection of wheel dimension
At any time, the user can change the dimension of the wheel. To do that, the perimeter dimension of the wheel is
viewed in millimetres and its equivalence in inches (16, 20, 24, 26, 27'5, 28 or 29). These dimensions can be modified
modified using the (+) and (-) buttons. The perimeter measuring of the wheel is done as follows:
7.2. Change between metric system (km) and imperial (miles), pressing (+) or (-).
7.3. Exclusive functions SNOW models.
The SNOW models have 2 motors, one in the front hub and one in the rear hub. Pressing the (+) and (-) buttons
allows choosing the monitoring mode, form among the following:
- ALL. The two motors work in parallel with the activated traction control.
- ECO. The two motors are coordinated and complemented to obtain energy effiviency.
- FRONT. Only the front motor works.
- REAR. Only the rear motor works.
- OFF. Select this option in the e-bikes that are not SNOW.
The SNOW models are not homologated under the regulation EN 15/94 and therefore are
designed for exclusive off-road use.
7.4. Select battery capacity (12 Ah,...) for correct range calculation.
Go into Se ngs
Change Wheel Size
Change KM to Miles
Change Motor Use (Snow)
Change Ba ery Capacity
Exit Se ngs
Perimeter of the wheel (mm) = Diameter of the wheel (D in mm) x 3,14
D (mm)
POWER
Sub index
0
1
2
3
U S E R M A N U A L
(+)
3 sec. 3 sec.
Increase Reduce
Km->Mile Mile->Km
Up Down
Increase Reduce
3 sec. automa c
EN
(-)
Same me
<3sec loop
27